811859
22
Zoom out
Zoom in
Previous page
1/32
Next page
GB
18
The whole "start zone" can go through up to 20 zones. It finishes after reaching a precisely defined
temperature at the "flame temperature sensor" and the control system puts the stove into "Heating mode".
The duration of the "start zone" can therefore vary.
If, during the start zone, no flame generation can be achieved or the required temperature at the "flame
temperature sensor" cannot be reached, a shut down process is initiated.
10.2. Heating mode
After the positive conclusion of the "start zone", the stove automatically switches to "Heating mode".
In "Heating mode", the heat output of the stove is adjusted in modular fashion to the room temperature or to
the difference between the Actual and Target room temperatures.
If the difference between the Actual and Target room temperatures is big, then the stove heats with a bigger
heat output.
The nearer the Actual and Target room temperatures get to each other, the more the stove's heat output is
reduced.
10.3. Burner test (burner cleaning)
During the "Heating mode" operating status, an automatic burner cleaning process is carried out at regular
time intervals (E.G. 30 minutes).
This process takes approx. 2 minutes.
10.4. Cooling down
If the set Target room temperature is reached or the "ON/OFF" button is pressed, then the operating status
switches to "cooling down". The cooling down phase is restricted by timing control (duration about 15
minutes). After the end of the "Cooling down" operating status, the appliance switches to "standby" operating
status or "OFF".
10.5. ECO-Mode
If the ECO-Mode mode is activated, the stove will not turn off when the "Target room temperature" is reached.
The stove continues to burn with a "smaller flame". If the "Target room temperature" is exceeded by more than
3 °C, then:
the stove enters the “Cooling down” operating mode
if the “Actual room temperature” exceeds 30 °C in the ECO-Mode operating mode, the stove enters the
“Cooling down” operating mode.
The ECO-Mode remains active in both cases.
10.6. Standby
The stove is in waiting condition. Before it can be switched over from the operating setting "standby" to the
operating setting "Start zones 1 20", two conditions for the start are to be fulfilled:
The "Actual room temperature" must drop under the "Target room temperature" by 1 °C at least
The temperature of the combustion products measured by temperature sensor must be lower than 70 °C
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haas-Sohn HSP 2.17 HOME II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haas-Sohn HSP 2.17 HOME II in the language / languages: English as an attachment in your email.

The manual is 1.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haas-Sohn HSP 2.17 HOME II

Haas-Sohn HSP 2.17 HOME II User Manual - German - 32 pages

Haas-Sohn HSP 2.17 HOME II User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info