Manual H.Koenig V85 (page 8 of 72) (English, German, Dutch, French, Italian, Spanish)

701984

Zoom out

Zoom in

1/72

Steam ironing.

1. Fill water tank with clean tap water refer to above filling instruction. For better performance,

please immerse filter in water for several minutes before installing it into the water tank).

2. Connect the unit into a suitable main socket. Turn temperature contrai dial to steam iraning

position, heating indicator light on iran unit lights up to indicate that the unit is being heated up.

When it turn off, the desired temperature has been reached,it is ready for steam iraning. Du ring

use,heating indicator light will cycle from ON to OFF and then OFF to ON, it indicates that the iran

is automatically heat preservation.

3. Before first time use of steam iraning, please clean the iran as below methods: Take the

iran unit up from the base unit, press steam button underneath the handle to allow steam release

for 30 seconds and then stop for 30 seconds, do so as a cycle, and repeat above cycle again. The

iran is not ready for using until the heating indicator light turns OFF.

4. During steam iraning, steam rate will be varied when temperature contrai dial is adjusted to

different positions. This can prevent water leakage caused from soleplate.

5. After using, take the iran unit back onto base unit,turn temperature contrai dail to "MIN", and

then unplug from main socket.

6. SI ide water tank out from the base unit and empty it.

Note:

a. For every first time use, it is normal thafs a slightly vibration sound may be occurred from

electrical pump inside the base unit for a few seconds when steam iraning started. lt is because

there is air inside the filter, it will stop till the air inside the filter has been pumped out. If this

abnormal conditions coutinuously happen for more than 60 seconds, please check whether water

tank and filter assembled correctly or not.

b. When temperature contrai dial is set at "synthetic" position. it only suits for dry iraning, max

steam will be obtained when set at "MAX" position, when set at "Wool" steam will be smaller

gradually.

Dry ironing

1. Connect the appliance to a suitable socket outlet.

2. Set temperature contrai dial to desired position according to iraning instructions on the

garment label or fabric setting chart. Heating indicator light (red) at iron unit lights up to indicate

the unit being heated up. When the heating indicator light turn off, the desired temperature has

been reached. During use, heating indicator light will cycle from ON to OFF and then OFF to ON. lt

indicates that the unit is heat preservation.

3. After using, take the iran unit back onto base unit, turn temperature contrai dial to "MIN",

and then unplug from main socket.

Note: When changing your Temp setting from higher setting to lower, it is proposed that not to

start iraning immediately since it may cause burns to your fabrics. Please wait till temperature

indicator light lights up steadily, and then start iraning.

Vertical steam ironing

Follow the steam ironing process, and then hold the iron in

vertical position between 5cm and 15cm away from the hanged

fabrics. Press down steam switch, this will create vertical steam.

This feature is especially used for removing creases from

hanging clothes and curtains. Never directly perform steam

ironing on people. (Fig.8)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of H.Koenig V85 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,19 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

H.Koenig V85 Manual

Product: