701222
5
Zoom out
Zoom in
Previous page
1/35
Next page
6. Press on/auto/off button once, the indicator in it will be illuminated red. The appliance will begin
working.
7. The brewing process can be interrupted by pressing the on/auto/off button twice at any time during
operation, and the indicator in it will be illuminated blue, after about 15s, it will be extinguished. The
appliance will continue brewing once on/auto/off is pressed again.
Note: You can take out the jug, pour and serve at any time. The appliance will stop dripping
automatically. But the time cannot exceed 30 seconds.
8. Remove out carafe to serve when finish brewing (about one minute later after the coffee stops
dripping out.)
Note: the coffee you get will less than the water you have added, as some water is absorbed by coffee
ground.
9. When the process is finished, if you do not want to serve immediately, keep the coffee maker is
energized, the coffee can be kept warm in the keeping warm plate. The appliance will be cut off power
automatically after 40 minute if it has not been manually disconnected at the completion of brewing.
For an optimum coffee taste, serve it just after brewing.
10. Always turn the coffee maker off and disconnect the power supply when not use.
Caution: When pour coffee, the momentary inclined angle of carafe shall not be more than 45 degree
from the vertical position, you shall pour the coffee slowly until the carafe is empty, otherwise the
coffee in the carafe will rush to the bottom of carafe lid, and the coffee will flow out from two edges of
lid and hurt person!
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it is 5:10 pm, you
hope that the coffee maker will automatically start at 8:15 in the evening, first follow steps
1 to 5 of above section, then you can set the auto m atic start function as follows:
1. Press PROG button one time, the word CLOCK is showed at the up-right corner on
display.
2. Press the HOUR and MIN button continuously to set the present time (real clock), that
is 17:10 (See fig. 1).
Note: the time cycle is 24 hours.
3. Press PROG button again and the word TIMER shows on up-left corner of display.
4. Set the delayed starting time by pressing HOUR and MIN button repetitively, that is
20:15 (see Fig. 2).
20:15
TIMER
Fig.2
Fig.1
CLOCK
17:10
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for H.Koenig TOPC558 - MG30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of H.Koenig TOPC558 - MG30 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info