665713
9
Zoom out
Zoom in
Previous page
1/64
Next page
9/64
ANOMALIES/CAUSES/REMEDES
Anomalies
Causes
Remèdes
L’appareil ne délivre pas de
courant et le voyant jaune de
défaut thermique est allumé.
La protection thermique du
poste s’est déclenchée.
Attendre la fin de la période de
refroidissement, environ 2 min. Le voyant
s’éteint.
L’afficheur est allumé mais
l’appareil ne délivre pas de
courant.
Le câble de pince de masse ou
porte électrode n’est pas
connecté au poste.
Vérifier les branchements.
Lors de la mise en route,
l’afficheur indique pendant
une seconde puis s’éteint.
La tension n’est pas dans la
fourchette
230 V +/-
15% pour le 208,
85 V - 265V pour le
207 FV.
Faire vérifier l’installation électrique.
Arc instable
Défaut provenant de l'électrode
en tungstène
Utiliser une électrode en tungstène de taille
appropriée.
Utiliser une électrode en tungstène
correctement préparée
Pour les courants faibles, augmenter la
fréquence
Débit de gaz trop important
Réduire le débit de gaz
L'électrode en tungstène s'oxyde
et se ternit en fin de soudage
Zone de soudage.
Protéger la zone de soudage contre les
courants d'air
Défaut provenant du Post gaz.
Augmenter la durée du post gaz
Contrôler et serrer tous les raccords de gaz
L'électrode fond Erreur de polarité
Vérifier que la pince de masse est bien
reliée au +.
Balance trop importante, fréquence trop
faible
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys TIG 208 AC-DC HF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys TIG 208 AC-DC HF in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info