625754

Gys STARTIUM 480E Manual

7
Zoom out
Zoom in
Previous page
1/28
Next page
7
STARTIUM 330E / 480E / 680E / 980E
EN
This manual contains safety and operating instructions. Read it carefully before using the device for the rst time and
keep it in a safe place for future reference.
GENERAL DESCRIPTION
STARTIUM devices are designed for charging and starting 12V (6 element) and 24V (12 element) lead acid batteries
(electrolyte, gel and AGM) :
Assembly - handle and wheels (only for the 480E, 680E & 980E) :
POWER SUPPLY
Check that the power and protection (fuse and / or circuit breaker) are compatible with the current required. The
appliance must be positioned so that the plug socket is accessible.
It must be connected to a grounded outlet according to the following recommendation:
STARTIUM 330E STARTIUM 480E STARTIUM 680E STARTIUM 980E
Power supply 230V - 1 ph 230V - 1 ph 230V - 1 ph 230V - 1 ph
Protection 16 A 16 A 16 A 16 A*
Charge power 800 W 1 700 W 2 000 W 2 000 W
Start power 6 500 W 9 000 W 10 000 W 12 000 W
Capacity
12V 20 - 375 Ah 20 - 600 Ah 20 - 675 Ah 20 - 750 Ah
24V 20 - 300 Ah 20 - 450 Ah 20 - 525 Ah 20 - 525 Ah
*In the event that starting a large vehicle is troublesome it may be necessary to t a 20A plug (not included).
Recommended cable section in case of extension lead : 3 x 2.5 mm².
CONNECTION AND DISCONNECTION
IMPORTANT! Before connecting to a battery, check that the device is not connected to the power supply and the switch
is OFF.
Secondly, check the polarity of your battery (the fuse breaks if the polarity has been reversed).
Attention: The cables must not be pinched or in contact with hot or sharp surfaces.• The device does not automatically
select the voltage of the battery. Ensure that the battery is connected according to the correct voltage, either 12 or 24V.
Starting and charging a battery connected on the vehicle :
Where the negative pole of the battery is connected to the vehicle chassis
• Connect the red clamp to the positive pole of the battery.
• Connect the black clamp to the vehicle chassis, ensure it is not close to fuel lines and the battery.
• Connect the device to the mains.
• After use, turn the switch to OFF (if any), then disconnect the charger from the mains supply then disconnect the black
clamp and nally the red clamp.
Some vehicles have the positive pole of the battery connected to the chassis, in this case:
• Connect the black clamp to the negative terminal of the battery.
• Connect the red clamp to the vehicle chassis, ensure it is not close to fuel lines and battery.
• Connect the device to the mains.
• After use, turn the switch to OFF (if any), then disconnect the charger from the mains supply then disconnect the red
clamp and nally the black clamp.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys STARTIUM 480E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys STARTIUM 480E in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info