665822

Gys NEOPULSE 270-T2 Manual

25
Zoom out
Zoom in
Previous page
1/50
Next page
25
NEOPULSE 270-T1 / 270-T2 / 300
EN
List of synergic modes (V1012)
Std Ø0.6 Ø0.8 Ø1 Ø1.2 Puls Ø0.6 Ø0.8 Ø1 Ø1.2
Fe Arg CO2 18% X X X X X
Al Mg 5 Arg 100% X X X X X X
Al Si 12 Arg 100% X X X X
Al Si 5 Arg 100% X X X X X
Cr Ni 308 Arg 100% X X X X
Cr Ni 316 Arg 100% X X X X
Cu Si 3 Arg 100% X X X X
Cu Al 8 Arg 100% X X X X
Fe CO2 100% X X
Information panel
It contains the indices and sub-indices of the circuits and
the software version (HMI, power, SD card ...)
Example:
WELDING STAGES
Standard 2 times mode
OFF
Istart
Dstart
Gas Pre-Flow
T burn-back
I burn-back
ON
Gas post-Flow
Pressing the trigger will start pre-gas. When the wire touches the workpiece a pulse boots the arc and the the
welding process starts. When you stop pressing the trigger, the wire feeder stops working and a current pulse will
cut the wire, and will be followed by post-gas. As long as the post gas is not nished, you can pull the trigger to
carry on the welding (delay in manual). To modify the parameters you have to wait until the end of the post gas.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys NEOPULSE 270-T2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys NEOPULSE 270-T2 in the language / languages: English, German, French as an attachment in your email.

The manual is 5,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info