786852

Gys JUMP LEADS REEL 350A Manual

5
Zoom out
Zoom in
Previous page
1/12
Next page
GENERAL INSTRUCTIONS
Read and understand the following safety recommendations before using or servicing the unit.
Any change or servicing that is not specied in the instruction manual must not be undertaken.
The manufacturer is not liable for any injury or damage caused due to non-compliance with the instructions featured in
this manual .
In the event of problems or uncertainties, please consult a qualied person to handle the installation properly.
SAFETY INSTRUCTIONS
The booster cable shall be used in gasoline engine under 5.5L or diesel engine under 3L.
The capacity of the battery (e.g. 45Ah) being used to provide power to the non starting vehicle must not be signi-
cantly less than that of the battery tted to the non starting vehicle. Also the batteries in both vehicles must be of
the same voltage.
Only batteries of the same nominal voltage (e. g. 12V) can be connected to the jumper cables.
During the ‘jump start’ ensure that the two vehicles are not touching.
Sources of ignition (e.g. naked ames, lighted cigars, cigarettes or sparks) must be kept away from the batteries
(risk of explosion). Avoid bending over the batteries due to risk of acid burns.
Do not lean too far over the starter batteries (risk of chemical burns). The electrolyte in a discharged starter battery
remains liquid even at low temperatures.
The discharged starter battery must not be disconnected from the electrical system of the associated vehicle.
Switch off the ignition of both vehicles before connecting the jumper cables. Ensure the hand brake / parking brake
is engaged. Vehicles with manual transmissions must be in neutral. Vehicles with automatic transmissions must be
set to position «P».
Place the leads of the jumper cable in such a position that they cannot get caught by any rotating parts inside the
engine compartment.
OPERATING PROCEDURES
Connection
1. Connect a clamp of the red cable to the positive terminal of the discharged battery.
2. Connect the other clamp of the red cable to the positive terminal of the functional battery.
3. Connect a clamp of the black cable to the negative terminal of the functional battery.
4. Connect the other clamp of the black cable to the ground of the immobilized vehicle (e.g.: ground wire or any me-
tal part of the chassis or engine).
Keep it away from the discharging battery to prevent explosive gases from being generated during ignition.
5
JUMP LEADS REEL 350 A EN
Translation of the original instructions
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys JUMP LEADS REEL 350A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys JUMP LEADS REEL 350A in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 1.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info