625749
5
Zoom out
Zoom in
Previous page
1/20
Next page
GENERAL DESCRIPTION
Thank you for choosing this GYS product which has been designed with great care. To get the best out of
your machine, please read the following instructions carefully, and keep for future reference.
The GYSTARTs are designed to start vehicles with liquid or gel electrolyte lead-acid batteries and also charge
liquid or gel electrolyte lead-acid batteries. They are for use on 12V or 24V batteries with a capacity
according to the table below :
GYSTART
724E
924-230
1224T
Charge
20>1000 Ah
30>1100 Ah
65>1350 Ah
Start
45>200 Ah
45>250 Ah
60>300 Ah
ELECTRICITY SUPPLY
This device must be plugged into an EARTHED power supply with the following characteristics :
GYSTART
724E
924-230
1224T
Voltage
230V single ph.
230V single ph.
400V 3 ph.
Protection
16A
40A
16A
Recommended cable section for use on extension cables: 3 x 2.5 mm² (4 x 2.5 mm² for the 1224T).
USE IN STARTING MODE (START)
Prior precautions
Do not disconnect the battery from the vehicle. If the battery is disconnected it can lead to information being lost
and possible failure in starting the vehicle.
Connecting and disconnecting
Switch off the product by selecting position “0”.
Connect the clamps: red to + terminal, black tobattery terminal. Select the correct voltage 12 or 24 V
for the battery.
NEVER disconnect the battery from the vehicle
Switch on the product by selecting “I”
Proceed to pre-charge (if necessary) for a few minutes with a current of about 1/5
th
of the battery’s capacity.
Sit behind the steering wheel in order to activate the remote control switch and the ignition at the same time.
A 5 second period is usually enough to start. Repeat the operation if needed.
When the engine’s motor starts, release the remote control switch and switch the device off - position « O ».
Disconnect the clamps from the battery.
In « Electronic Control » position, Gystart protects the on-board electronics and avoids overvoltage
( : <14,8V : <29,6V). In Manual position, this protection is not activated.
USE IN CHARGING MODE (CHARGE)
Prior precautions
Choose a sheltered area with suitable ventilation.
Remove the battery caps (if present) and ensure the liquid level (electrolyte) is correct. Add some
distilled water if necessary. Carefully clean the lugs and terminals of the battery.
Check that the capacity (Amps per hour) and the voltage (Volts) are compatible with your charger.
Connecting and Disconnecting
Switch off the product by selecting position “0”. Then plug into the mains supply and turn the charge
current potentiometer to the lowest setting.
Select the correct voltage 12 or 24 V for the battery.
Connect the clamps: red to + terminal, black tobattery terminal.
Make sure you get good electrical contact.
Select the charging mode using the switch :
“Electronic control”: when the charging process is over, a light will illuminate.
“Manual mode”: stop the charging process when your battery starts to boil.
Be careful of explosive gas, avoid
flames or sparks.
Switch on the product by selecting “I”
After one minute of charge adjust the charging current using the control knob.
5
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys GYSTART 724E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys GYSTART 724E in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gys GYSTART 724E

Gys GYSTART 724E User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info