625731

Gys BATIUM 7-24 Manual

6
Zoom out
Zoom in
Previous page
1/23
Next page
6
BATIUM 7/12 • 7/24 • 15/12 • 15/24BATIUM 7/12 • 7/24 • 15/12 • 15/24
EN
This manual contains safety and operating instructions. Read it carefully before using the charger for the rst time and keep it in a
safe place for future reference.
GENERAL DESCRIPTION
Batium is designed for charging lead acid, GEL and AGM battery :
- from 15 Ah to 130 Ah in 6V or 12V for the 7/12 model (3 or 6 2V elements), in 6V, 12V or 24V for the 7/24 model (3, 6 or 12 2V
elements).
- from 35 Ah to 225 Ah in 6V and 12V for the 15/12 model (3 or 6 2V elements), and in 6V, 12V or 24V for the 15/24 model (3, 6
or 12 2V elements).
CONNECTION AND OPERATION
Follow the connection instruction as below:
Precaution: Check electrolyte level if possible and ll if necessary before charging.
1. Plug the charger into the mains (230V). Indicators (A) and (B) which correspond to the last setting used switch on.
2. Select your battery voltage (6V, 12V, 24V) according to the indications written on your battery or to the coupling done. (in series
or parallel see P23).
3. Select the capacity of the battery. The Batium will select the charging current automatically.
4. Connect the clamps: Red clamp on the battery “+” and black clamp on the “–“.
5. Batium starts charging automatically and will indicate after 30 seconds the de-sulphation process only if the battery is deeply discharged.
The indicators 1 and 2 indicate the charge state of your battery.
Phase 1 :
Voltage rise
Permanent
Phase 2 :
Voltage regulation (during 2 hours)
Flashing Light
Phase 3 :
Charge end (Floating)
Green
During a power cut, Batium stores the charge state (except in « SOS Recovery » mode), so the charge can continue (phase 1).
6. When the battery is charged, disconnect the power cable.
7. Disconnect the clamps or the battery connector.
FUNCTION « FORCED CHARGE »
If the battery is deeply discharged (very low voltage <2V), the charge will not start automatically. The charge indicator 1 does not
switch on. The battery voltage indicators, (A) and capacity (B) switch on. In this case, select the voltage and the charging current
then press the battery voltage key (3) for 5 seconds to start a « forced charge ». The indicator 1 will switch on when the key is
released. If no indicators switch on, your battery is unrecoverable (<0.8 V).
« SOS RECOVERY » FUNCTION (AVAILABLE FOR BATIUM 15-12 & 15/24
If the SOS Recovery indicator (6) ashes when a deeply discharged battery is connected and a de-sulphation process has started.
The « SOS Recovery » function delivers a specic charging curve between 24 to 48 hours to recover the battery. To activate this
function follow the steps below:
1. The vehicle battery MUST BE DISCONNECTED. (OVERVOLTAGE DANGER)
2. Connect Batium to the mains
3. Select charging voltage
4. Activate « SOS Recovery » by pressing the key 4 for 5 seconds until the indicator 6 switches on (the indicators (B) are off).
5. Connect the Batium clamps to the battery.
6. The green indicator 2 will light up to notify the end of the charge.
PROTECTION
The Batium is protected against short-circuits, polarity inversions and engine starts. It has an anti-spark feature which prevents
sparks whilst the battery is connected to the Batium. The Batium will not deliver current if there is no battery detected (no voltage
in the clamps)
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys BATIUM 7-24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys BATIUM 7-24 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info