Manual Gys BATIUM 15-12 (page 6 of 23) (English, German, Dutch, French, Italian, Portuguese, Spanish)

625730

Zoom out

Zoom in

1/23

BATIUM 7/12 • 7/24 • 15/12 • 15/24BATIUM 7/12 • 7/24 • 15/12 • 15/24

This manual contains safety and operating instructions. Read it carefully before using the charger for the rst time and keep it in a

safe place for future reference.

GENERAL DESCRIPTION

Batium is designed for charging lead acid, GEL and AGM battery :

- from 15 Ah to 130 Ah in 6V or 12V for the 7/12 model (3 or 6 2V elements), in 6V, 12V or 24V for the 7/24 model (3, 6 or 12 2V

elements).

- from 35 Ah to 225 Ah in 6V and 12V for the 15/12 model (3 or 6 2V elements), and in 6V, 12V or 24V for the 15/24 model (3, 6

or 12 2V elements).

CONNECTION AND OPERATION

Follow the connection instruction as below:

Precaution: Check electrolyte level if possible and ll if necessary before charging.

1. Plug the charger into the mains (230V). Indicators (A) and (B) which correspond to the last setting used switch on.

2. Select your battery voltage (6V, 12V, 24V) according to the indications written on your battery or to the coupling done. (in series

or parallel see P23).

3. Select the capacity of the battery. The Batium will select the charging current automatically.

4. Connect the clamps: Red clamp on the battery “+” and black clamp on the “–“.

5. Batium starts charging automatically and will indicate after 30 seconds the de-sulphation process only if the battery is deeply discharged.

The indicators 1 and 2 indicate the charge state of your battery.

Phase 1 :

Voltage rise

Permanent

Phase 2 :

Voltage regulation (during 2 hours)

Flashing Light

Phase 3 :

Charge end (Floating)

Green

During a power cut, Batium stores the charge state (except in « SOS Recovery » mode), so the charge can continue (phase 1).

6. When the battery is charged, disconnect the power cable.

7. Disconnect the clamps or the battery connector.

FUNCTION « FORCED CHARGE »

If the battery is deeply discharged (very low voltage <2V), the charge will not start automatically. The charge indicator 1 does not

switch on. The battery voltage indicators, (A) and capacity (B) switch on. In this case, select the voltage and the charging current

then press the battery voltage key (3) for 5 seconds to start a « forced charge ». The indicator 1 will switch on when the key is

released. If no indicators switch on, your battery is unrecoverable (<0.8 V).

« SOS RECOVERY » FUNCTION (AVAILABLE FOR BATIUM 15-12 & 15/24

If the SOS Recovery indicator (6) ashes when a deeply discharged battery is connected and a de-sulphation process has started.

The « SOS Recovery » function delivers a specic charging curve between 24 to 48 hours to recover the battery. To activate this

function follow the steps below:

1. The vehicle battery MUST BE DISCONNECTED. (OVERVOLTAGE DANGER)

2. Connect Batium to the mains

3. Select charging voltage

4. Activate « SOS Recovery » by pressing the key 4 for 5 seconds until the indicator 6 switches on (the indicators (B) are off).

5. Connect the Batium clamps to the battery.

6. The green indicator 2 will light up to notify the end of the charge.

PROTECTION

The Batium is protected against short-circuits, polarity inversions and engine starts. It has an anti-spark feature which prevents

sparks whilst the battery is connected to the Batium. The Batium will not deliver current if there is no battery detected (no voltage

in the clamps)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gys BATIUM 15-12 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gys BATIUM 15-12 Manual

Product: