764736

Gymform Total Fitness Manual

6
Zoom out
Zoom in
Previous page
1/14
Next page
ENGLISH
Product Description:
1. Base supports
2. Rails
3. Elastic bands
4. Foot support hole
5. Foot support
6. Wheels
7. Counter holder
(counter not included)
8. Seat nut
Safety Warnings
Read the instruction manual before using Gymform® Total Fitness for the rst
time.
If you have any doubts about your physical condition or have suffered from an
illness, always consult your doctor before using Gymform® Total Fitness.
If you have a spinal disc herniation, consult your doctor before using the product.
If you suffer from asthma or any other respiratory disease, consult your doctor
before using Gymform® Total Fitness.
Always use Gymform® Total Fitness on a at surface.
Ensure that children do not use Gymform® Total Fitness without adult supervi-
sion.
Do not use if you are pregnant.
Do not drink alcoholic beverages while using the device.
Drink water after use. The maximum weight for this product is 120 kg.
For a safe, comfortable workout, leave a minimum of 0.6 m of free space around
the device.
To use this device correctly, do the exercises indicated in the Exercise Guide.
Do not do any other exercises, since you may injure yourself by using the device
incorrectly.
Warning: Do not use the device for therapeutic purposes
CERTIFICATES AND DIRECTIVES
Class HC
Model no. VDPGYCIND0057
This product meets the requirements of the Standard Directive
EN ISO 20957-1:2013 and EN 957-2:2003.
PRODUCT ASSEMBLY:
A. Attach the base supports (1) to the elastic bands (3) in a cross position:
B. Attach the rails (2) to the base supports (1) . The foot support hole (4) must be
in the wheeled base support (6):
C. First, fasten the base support (1) and the rails (2) with a screw (C.1), tighten
the washer and female attachment by hand. Then, fasten the other base support
(1) with a screw on the same side as shown in the illustration (C.2), tighten the
washer and female attachment by hand. Fasten the other two screws in the same
way (C.3 - C.4).
D. When the four screws, washers and female attachments have been tightened
by hand, further tighten them with the hexagonal wrench (14) and the Allen key
(15) provided.
Note: If the area where you are going to use Gymform® Total Fitness is not
completely at, it is possible to adjust the height of the wheeled base support
(1), by screwing or unscrewing the adjustable suction cups (17) from the base.
E. Place the foot support (5) in the foot support hole (4), the counter holder (7)
must remain inside the product. First x it with the bolt (16) in the lower hole. The
foot support has two positions, choose the position required and x it using a bolt
(16) in the upper hole.
F. Remove the seat padding. Place the seat back (13) in a vertical position, then
push the seat back down until it is xed in place.
G. Cut the seat’s cable ties.
How to attach the seat: To position the seat (12) between the rails (2) pull the
seat nut (8) and turn it a quarter turn to the right. When the seat (12) moves to the
middle of the rails (2), it will be hold (or attached) in the correct position. This is
an option for certain special exercises (see the Exercise Guide).
To unblock the seat, pull the seat nut (8) and turn it to the left.
H. Attach the handles (9) under the seat (12), removing the screws rst, and co-
rrectly position each handle as shown in the illustration. Then, attach the screws
as shown in the illustration.
Note: Before this step, attach the seat (12) as described above in the How to
attach the seat section to ensure comfort and safety
I. The nal step is to use the hook to x the handles (10) to the rings on the elastic
cords (11). Depending on the exercise you want to do, you can put the elastic
bands on the front or the back (see Exercise Guide)
Storage:
To store the product, pull the seat back (13) upwards and fold it over the seat
(12). To position the seat (12) between the rails (2) pull the seat nut (8) and turn it
a quarter turn to the right. When the seat (12) moves to the middle of the rails (2),
it will be hold (or attached) in the correct position. Ensure that the foot support (5)
is completely perpendicular to the rails (5). Lift the base from the other side of the
foot support (5) and use the wheeled base support (6) to move your Gymform®
Total Fitness to wherever you want to store it. If the foot support (5) is resting on
the oor, the product will remain upright. Store the product in an area where it will
not be knocked as this could cause it to fall over.
Quality Warranty:
This product is covered by a warranty against manufacturing defects subject to
the time periods stipulated by the legislation in force in each country.
This warranty does not cover damages resulting from inadequate use, negligent
commercial use, abnormal wear and tear, accidents or improper handling.
Australia & New Zealand only
This product has the benet of certain Consumer Guarantees. These are prescri-
bed by the Australian Consumer Law & the New Zealand Consumer Guarantees
Act 1993 both of which provide protection for consumers. There is no express
warranty for this product in Australia or New Zealand. The above paragraph
refers to other countries.
Made in China.
9. Grips
10. Handles
11. Rings for elastic bands
12. Seat
13. Seat back
14. Hexagonal wrench
15. Allen key
16. Bolt
17. Adjustable suction cups
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gymform Total Fitness at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gymform Total Fitness in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info