Manual Gude V 421 C 85074 (page 10 of 68) (English, German, Dutch, French, Italian)

628819

Zoom out

Zoom in

1/68

Parts of the packaging (e.g. foil, styropor) may be dangerous

for children. Risk of suffocation! Keep these parts of the

packaging out of reach of children and dispose as soon as

possible.

In the EU, this symbol refers to the fact the given

product is not allowed to be disposed as

household waste. Old appliances contain

valuable materials that can be recycled and you

should take them to a collection point to prevent

any damage to the environment and human health by

uncontrolled waste disposal. Therefore, dispose any old

appliances through collection points or send them for disposal

to where you have bought them. By this, some materials from

these appliances will be reused.

Operator Requirements

The operator shall read the instruction manual carefully

before using the unit.

Qualification

No special qualification is required for use of the unit except

for detailed direction by a professional.

Minimum Age

Only persons above 16 years of age are allowed to work with

the unit. Exempted from the provision is the use of the

juvenile trainees if they work in the course of their

professional training with an aim to obtain the skill under

trainer supervision:

Training

Use of the unit requires adequate lesson by a professional or

the use of the manual only . Special training is not required.

Technical Data

Connector: 230 V/50-60 Hz

Charging voltage at start: 12V / 24 V

Charging rms current: 60 A

Charging arithmetic current: 40 A

Starting current app.: 0 V: 390 A

1.5 V: 240 A

Max. input: 8 kW

Min. protection: 16 A

Rated capacity: 20-1000 Ah

Battery start: 35-50 Ah (without

previous charging)

65-100 Ah (with previous

charging)

Weight: 16 kg

Dimensions (mm): 330 x 250 x 600

Transportation and Storage

• If putting the unit away for a prolonged storage, it should

be cleaned thoroughly.

• Protect the unit from weather effects with a tarpaulin,

carton etc.

Assembly and Initial Operation (Fig. 4+5+6)

Screw on the handle according to (Fig. 5).

Put the axle through the charger (Fig.1/2). Fit the supplied

safety rings on. Mount the wheels (Fig.1/1) on the axle and

secure them with safety rings (Fig .6).

Put the wheels covers on.

Screw on the foot (Fig. 1/4) using the supplied screws

(Fig.1/3).

Operation

Unplug before any adjustment and set up.

Charging (Fig .3)

• Connect the charger to the battery to be recharged

• Always connect the black cable first, to the negative pole.

Connect the red pole cable to the positive pole.

The battery should be completely disconnected from

the vehicle before getting down to charging.

• Always set the charger at the lowest charging degree

(min/1) (Fig.3/8)

• Now, plug in and control the charging degrees upwards

until charging current equal to ca 10% of the battery

capacity is displayed.

• Charging degrees may be increased by falling charging

current. (Fig.3/7)

• Do not disconnect the battery from terminals later than

3-5 hours after charging is finished.

•

Notice. The charging current indicator will not

come back to zero after charging is finished.

Charging Time

• The charging time always depends on the battery status

(nearly charged, half-charged or completely discharged)

• To recover a battery that is normally in use 2 – 4 hrs are

sufficient, while for full recharging 8-10 hrs are needed.

•

Charging time should not be exceeded (10 hrs

max.).

Start-up Assistance

• CAUTION! At the startup process can overvoltages

arise, the on-board electronics could damage their

vehicle. Please discuss with your automotive specialist.

• Connect the batteries as shown in part “Charging” and

leave it connected to the vehicle!

• On principle, two persons should always start up a

vehicle with chargers.

• The charger on max. Performance are:

Switching stage 2 (Fig. 3/7) and "BOOST" (Fig. 3/8).

• The first person shall push the Start button on the

charger (Fig. 3/9). The other one shall immediately start

the ignition, max. 9-10 sec.

• As the vehicle starts up, stop starting immediately

• If the attempt to start fails, wait about 5 minutes for the

charger to get cooled and only then begin another

attempt to start.

Tip: If you change the battery for 10-15 minutes to

subpoena requires much less battery power startup.

Warning: The fuses may burn through and the

vehicle damaged if the starting time is more than 10 s.

Note: The terminals may not touch.

Notice: The charger is equipped with overload

protection.

Important: A change of drop-out fuses for fuses (pic. 3/5)

not corresponding to fuses in the appliance can cause

material damage or injury of persons.

Change the drop-out fuses only when the power cord is

unplugged!

Operator Safety Instructions

• Any safety and protection devices must be fitted in

place before switching the unit on.

• It is forbidden to attempt starting vehicles, the batteries

of which are discharged or damaged as that would

result in damaging the unit.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gude V 421 C 85074 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,76 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gude V 421 C 85074 Manual

Product: