623612

Gude KS 500 B 94104 Manual

36
Zoom out
Zoom in
Previous page
1/104
Next page
32
KS 500 B | KS 400 BW | KS 450 B | KS 501 BENGLISH
GB
Defects searching
Defect Cause
The motor does not start 1. Put the operational switch to OFF
position
2. Empty fuel tank
3. Over oated motor
4. Sooted spark plug (carbon residues on
electrodes), electrodes distance too big
5. Dirty carburettor, dirty carburettor
nozzles
6. Damaged spark plug contact, faulty
ignition cable
7. Missing spark
1. Put the operational switch to ON
position
2. Top-up fully the fuel tank
3. Reduce throttle, start couple times, in
case of necessity dismantle spark plug,
clean and dry it
4. Clean the spark plug, check the plug
thermal value, possibly change the
plug, set the electrodes distance to
0.6-0.7 mm
5. Let the carburettor cleansed, blow
through by air in authorized workshop
6. let changed in authorized workshop
7. Check the switch-o button, cable and
ignition module, poss. Let replaced in
authorized workshop, let adjusted gap
to 0.3-0.4 mm
Idle speed too high 1. Cold engine 1. Heat up slowly, poss. Close slightly
choke
Engine does not give
max. output
1. Sooted spark plug (carbon residues on
electrodes), electrodes distance too big
2. Dirty carburettor, dirty carburettor
nozzles
3. Dirty air lter
4. Exhaust, exhaust channel of cylinder
5. Leaky sealing gasket in crankcase
6. Worn-down cylinders, pistons, piston
rings
7. Bad fuel/oil mix (too much oil)
8. Bad ignition
1. Clean the spark plug, check the plug
thermal value, possibly change the
plug, set the electrodes distance to
0.6-0.7 mm
2. Let the carburettor cleansed, blow
through by air in authorized workshop
3. Clean
4. Let the exhaust dismantle and clean
in authorized workshop, let clean the
carbon residues
5. Let replaced in authorized workshop
6. Let replaced cylinders, pistons and
piston rings in authorized workshop,
let the cylinders ground with end lap
and let installed oversize piston
7. Fill the fuel tank according to the
manual
8. Contact gap size of ignition module
(0.3-0.4 mm) let adjusted in authorized
workshop
Motor can not be swit-
ched o
1. Light-grey spark plug with traces of
burning (melting pearls)
2.residues of carbon in the combustion
chamber
1. Install spark plug of higher thermal
value
2. Let cleaned the cylinder head, piston
top and cylinder channels in autho-
rized workshop
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude KS 500 B 94104 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude KS 500 B 94104 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 5,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info