628922

Gude IND. 25 E 85100 Manual

8
Zoom out
Zoom in
Previous page
1/102
Next page
suffi cient and may activate the fl ame cut out mechanism, which
will turn off the heater;if this happens, wait for about a minute
and then press the reset button 1 (Fig. 2) to start the machine
again.
The fi rst steps to take if the machine does not work are the
following:
1. Check that there is fuel in the tank.
2. Press the reset button 2 (Fig.2) ON.
3. If the heater still does not work, consult the
“TROUBLESHOOTING”guide.
TURNING OFF THE HEATER
To turn off the machine, move switch 1 (Fig. 2) to the “0” position
The fl ame will go off and the fan will continue to function until the
combustion chamber has cooled down completely.
SAFETY DEVICES
The heater is equipped with an electronic device to control the
fl ame.If there is an anomaly in the functioning, the machine will
be turned off and the reset button light 2 (Fig.2) will come on.
An over-heating thermostat cuts in and shuts off the fuel supply
if the heater overheats:the thermostat resets itself automatically
when the temperature in the combustion chamber diminishes
and reaches the maximum permitted value.
Before turning the heater on again, the cause of the overheating
must be identifi ed and removed (for example, a blockage in the
suction orifi ce and/or of the air fl ow duct, the non-functioning
of the fan). To turn on the machine again, press the reset but-
ton and repeat the specifi c instructions outlined in the section
“STARTING THE HEATER”.
MOVING AND TRANSPORTING
THE HEATER
WARNING The following steps must be carried out befo-
re moving the heater: turn the heater off, following the
instructions in the previous section; disconnect the plug
from the power supply and wait for the heater to cool.
Before lifting or moving the heater, make sure that the fuel tank
cap is fi rmly in place.
To move the heater, simply grasp the support handle and wheel
the heater.
PREVENTATIVE MAINTENAN-
CE PROGRAMME
To ensure that the heater continues to work properly, it is neces-
sary to periodically clean the combustion chamber, the burner
and the fan.
WARNING The following steps must be carried out befo-
re servicing the heater: turn the heater off, following the
instructions in the previous section; disconnect the plug
from the power supply and wait for the heater to cool.
Every 50 hours of use it is necessary to:
• Dismantle the fi lter cartridge, remove it and clean it with clean
fuel oil.
• Remove the exterior cylindrical casing and clean the inside
and the blades of the fan.
• Check the condition of the cables and the high voltage connec-
tions on the electrodes.
• Dismantle the burner, clean the parts, then clean the electro-
des and regulate them to the distance indicated on page 95 in
the electrode regulation diagram.
HOT AIR GENERATOR
8
GB
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude IND. 25 E 85100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude IND. 25 E 85100 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info