628568

Gude HWW 1200 2 Manual

30
Zoom out
Zoom in
Previous page
1/43
Next page
General Safety Instructions
Read carefully the whole Operation Manual before first use of
the device. If there are any doubts about the connection and
operation of the device, contact the manufacturer (service
department).
OBSERVE CAREFULLY FOLLOWING INSTRUCTIONS SO
THAT THE HIGH SAFETY LEVEL MAY BE GUARANTEED:
Caution: The operation is permitted only with
protection switch against insufficient current (maximum
insufficient current 30 mA according to VDE regulation
part 702). Please consult your electrician-specialist.
The pump shall never be used as a circulating pump in
swimming pools.
Attention: Principally make sure the cooling of the engine is
optimal. Minimum distance from the fan grid should always be
at least 40 cm. Never cover the pump and/or never install it
into a tight shift. Ensure good removal of operation heat.
The pump is not suitable for swimming pools. Electric
installation may be performed only by a specialist. The pump
shall be supplied through installation of a device protecting it
against insufficient current.
Do not allow the pump to be operated without water and
without water supply. Otherwise the pump service life will be
endangered and the engine may be damaged..
Never envelop the pump head engine with a blanket or a
scarf to prevent freezing of water in cold weather.
Do not use pump at outside temperatures over 40 °C or under
0 °C and with water temperature over 35 °C.
The pump shall never be used for other liquids than water.
Do not use sand containing water, the sand may destroy
sealing.
Read carefully Operation Manual before installation and
putting into operation. The persons not acquainted with the
pump operation should carefully read the relevant Operating
Manual for operation and maintenance before putting the
pump into operation, in order to prevent damaging the pump
from the very beginning.
The user is responsible for third persons on the workplace.
The pump may be put into operation exclusively with a cable
or rubber electric extension cord type H07RNF, according to
standard DIN 57282 or DIN 57245.
The pump shall not be lifted, transported or fixed by pulling
the electric connecting cable.
Should cable or a plug be damaged due to external impacts,
the cable shall not be repaired! The cable shall be replaced
by a new cable.
This work may be performed only by an electrician-specialist.
Make sure that the connecting lines to electric sockets are
protected against flooding and moisture.
It is necessary to check before use if the connecting cable
and electric plug are in order. The pump shall be placed on
flat, stabile and horizontal plane.
Pull the plug out of the socket before any work.
The user is responsible for observation of local regulations
related to safety and built-in system.
Before every use check the device visually. Do not use the
device if the safety equipments are damaged or worn out.
Never put the safety equipment out of operation.
The device shall be used exclusively for the purpose given in
thie Operation Manual.
You are responsible for safety in the working region.
If the pump is faulty, the repair shall be performed exclusively
in the repair shops authorized to do so. Only original spare
parts may be used
It is necessary to take relevant measures for preventing the
placing of the device within the reach of children.
Before putting into operation it is necessary to find out by a
professional test if all required electric protection measures
are available.
During operation of home water station nobody may stay in
the medium being repumped.
Prevent the home water station to be exposed to direct water
current.
The owner is responsible for observation of safety provisions
and of provisions for built-in system.
(Consult the electrician-specialist, if necessary)
The pump is not suitable for long-term operation (e.g.
as a circulation pump in ponds or brooks). The service life
gets shorter accordingly if the pump is used in this manner. In
such a case, use a switching clock and ensure sufficiently
long breaks between the operating cycles.
The pump must not be connected to the existing water
supply system as equipment increasing the pressure.
The pump is not suitable as a long-term, automatic
safety against overflow of tanks and wells or for control of
underground water in cellars.
Do not leave the pump unattended to prevent damage
as a result of any faulty function. Always disconnect the pump
from network if not used.
The producer does not guarantee for any damage caused by
unqualified installation or unprofessional operation of the
pump.
The equipment must be regularly inspected and its faultless
condition needs to be checked.
Before each putting into operation, the pump must be visually
inspected for any damage (especially on the power supply
cable and plug). Using a damaged pump is strictly prohibited.
Electrical safety:
DANGER! Electric shock!
Danger of electric current accident!
● Pull the plug out of the network before filling, after
putting out of the operation, when repairing the failures.
Operation is permitted only on connecting lines
furnished with the insufficient current switch (PRCD)!
●Please ask the electrician-specialist.
The data on the type label shall comply with the electric
network data.
Protect the cable against heat, oil and sharp edges.
For Austria
The electric connecting line in Austria shall comply with the
ÖVE-EM 42, T2 (2000)/1979 § 22 pursuant to 2022.1.
According to this regulation the pumps may be operated for
use in swimming pools and garden lakes only via separating
transformer.
●Please consult your electric professional company.
For Switzerland
In Switzerland the devices used outside are different in
various locations, and shall be connected via insufficient
current protection switch.
General Instructions:
●Before every use perform visual inspection to make sure
that the pump, particularly the network cable and the plug are
not damaged.
A damaged pump shall not be used.
●In case of a failure the pump shall be checked by the GÜDE
Service or by an authorized electrician-specialist.
Do not expose the pump to rain and do not operate it in wet or
moist environment. The pump must not work without water,
therefore make sure that the end of the suction hose is
permanently in the medium to be repumped.
●Before every putting into operation the pump shall be filled
with the liquid to be repumped up to the overflow!
When pump is used for supplying the water in a house, the
local regulations of authorities for water and waste water
management shall be observed.
The provisions of DIN 1988 shall also be observed.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude HWW 1200 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude HWW 1200 2 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info