628566

Gude HWW 1000 IE Manual

10
Zoom out
Zoom in
Previous page
1/44
Next page
The electric connection shall be performed by means of a
socket.
Voltage examination. Technical data on the label shall comply
with the electric network voltage.
If the pump is used for ponds, wells etc. and in corresponding
water equipments, the standards applicable in the countries where
the pump is used shall be unconditionally observed.
Electric pumps used outside (e.g. at the ponds etc.) shall be
furnished with rubber electric cable type H07RNF, according to
standard DIN 57282 or. DIN 57245.
When the pump is in operation, no people or animals are
allowed to stay or dive in the liquid being repumped (e.g.
in swimming pools, in cellars etc.).
The repumped liquid temperature shall not exceed +35 °C.
Should extension cables be used, they shall be made
exclusively of rubber, type H07RNF, according to standard
DIN 57282 or DIN 57245. The pump connected to the
electric network shall never be touched by a cable, never
lifted by holding the cable or transport by means of a cable.
The connecting socket shall always be in necessary
distance from water and moisture and the plug shall be
protected against moisture.
Before putting the pump into operation check if the electric
cable and/or the socket are not damaged.
Before performance of any works on the pump the plug
shall be pulled out of the socket..
If the pump is built-in in a gully, the gully shall be covered
with cover to ensure the safety of people walking there.
The pump shall never be installed in moist shifts
(danger of shortcut, damage caused by corrosion)!
For avoiding or prevention of possible damage (as e.g.
flooding the rooms etc.) due to faulty pump operation
(e.g. due failure or defects) the owner (user) shall take
reasonable safety measures (installation of alarm
equipment, a spare pump etc.)
In case of failure on the pump,. the repair shall be
performed exclusively by an authorized service
repairshop.Only original spare parts may be used.
We have to draw your attention to the fact that
according to the valid standards we cannot take
responsibility for below mentioned cases of possible
damage caused by our devices:
Unproper repairs performed by unauthorized service repair
shops;
Using pump for a different purpose or failing to observe its
use according to the provisions;
Overloading of the pump by long-term operation;
Frost damage and other defects caused by weather
conditions;
The accessories are the same rules.
If damage to the cable of the unit then please
contact a qualified electrician. Remove from
handwritten repairs under any circumstances.
This device is not intended for use by persons
(including children) with reduced physical, sensory or
mental. Even people with lack of experience or
knowledge about the device is prohibited from working
with the device.
Never let unauthorized persons, especially children,
left unattended in the vicinity of the device. Instruct
children to keep unauthorized people away from the
always on device.
Electrical safety:
DANGER! Electric shock!
Danger of electric current accident!
● Pull the plug out of the network before filling, after
putting out of the operation, when repairing the failures.
Operation is permitted only on connecting lines
furnished with the insufficient current switch (PRCD)!
●Please ask the electrician-specialist.
The data on the type label shall comply with the electric
network data.
Protect the cable against heat, oil and sharp edges.
For Austria
The electric connecting line in Austria shall comply with the
ÖVE-EM 42, T2 (2000)/1979 § 22 pursuant to 2022.1.
According to this regulation the pumps may be operated for
use in swimming pools and garden lakes only via separating
transformer.
●Please consult your electric professional company.
General Instructions:
●Before every use perform visual inspection to make sure
that the pump, particularly the network cable and the plug are
not damaged.
A damaged pump shall not be used.
●In case of a failure the pump shall be checked by the GÜDE
Service or by an authorized electrician-specialist.
Do not expose the pump to rain and do not operate it in wet or
moist environment. The pump must not work without water,
therefore make sure that the end of the suction hose is
permanently in the medium to be repumped.
●Before every putting into operation the pump shall be filled
with the liquid to be repumped up to the overflow!
When pump is used for supplying the water in a house, the
local regulations of authorities for water and waste water
management shall be observed.
The provisions of DIN 1988 shall also be observed.
Behaviour in case of emergency
Provide necessary first aid treatment corresponding to the
injury nature and seek qualified medical help as soon as
possible.
Protect the injured person from other injuries and calm
him/her down.
First aid kit must always be available in the place of your
work in case of accident in accordance with DIN 13164.
Material taken out of the first aid kit needs to be
supplemented right away.
If help is needed, please provide the following details:
1. Place of accident
2. Accident nature
3. Number of injured persons
4. Injury type
Marking:
Product safety:
The product complies with the
relevant EC standards
Prohibitions:
Do not stay in the medium being
repumped
Keep the product out of the reach
of children
Do not pull the cable/transpor
devoce by holding the cable
Medium to be repumped up to
35 °C
10
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude HWW 1000 IE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude HWW 1000 IE in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info