Manual Gude GSZ 100-200 55050 (page 11 of 80) (English, German, Dutch, French, Italian)

628782

Zoom out

Zoom in

1/80

Important safety instructions

• The cable winch must be checked before starting work if

all components are working perfectly. In particular, check

the perfect state of the snap hooks preventing any

unintentional release of the lifting hook from slings

(ropes, rings, transportation eyes, etc.).

• The cable reel can only be used for lifting of burdens

whose weight does not exceed the maximum load

capacity specified by the producer in technical data

and on the type label of the cable reel.

• Burdens fixed in conflict with regulations that could fall

down must not be lifted.

− Attach the load correctly.

− Lifted loads may only be lifted in a vertical position!

Never pull and lift in an inclined position!

• No persons – except for the operator – may stay under

the load or in the dangerous area. Keep the minimum

distance of 10 m from the lifted load.

• All lifting work is only allowed when appropriate fixing

elements (cables, rings, transport loops, etc.) are used

and when in accordance with appropriate provisions

and standards valid in the workplace.

• The reel metal cable must not be used for burden

fixing.

• Putting the cable reel into operation is only allowed

with a perfectly balanced cable.

• The cable reel cannot be left unattended with burdens

lifted up.

• The load capacity of bearing structures must be

checked before you start working with the cable reel.

• Check the cables for any wear-out before you start

working with the cable reel; if there are any signs of

wear-out the cables need to be replaced with new ones

whose characteristics must correspond to the

maximum allowed load capacity of the cable reel.

Cables only need to be replaced with original spare

cables.

• If you face any problems with working of the cable reel

please contact your authorised dealer and refrain from

any improvisation work.

• The cable reel engine drive is not fitted with an engine

protection circuit-breaker. The engine therefore cannot

be overloaded when there are any problems with

lifting; in such a case check whether the lifted burden

does not exceed the allowed load capacity of the cable

reel and whether the system voltage has not dropped.

• To be able to intervene in time in case of any imminent

danger, the operating staff must operate the cable reel

from a suitable place to control the entire workplace.

•

Make sure the cable always reels up smoothly

on the drum. pic. 5

• Make sure the cable reel cable is always twined

around the drum at least thrice when working.

• The cable reel must not be changed anyhow; use only

devices supplied with the cable reel for lifting.

• Use the lifting devices supplied with the cable reel only

in a manner described in these Operating Instructions.

Do not use these devices for any other appliance or

purpose.

• Do not use an adhesive tape or any other tools for

connecting the feeder cable to the extension cable.

• Make sure the electric characteristics of the network for

cable reel connection correspond to the values

specified on the engine type label.

• When an extension cable is used, make sure that the

cable with the plug and socket correspond to the cable

reel input.

•

The steel cable needs to be checked for any

damage each time you put it into operation. It is

strictly prohibited to use the cable reel when the

cable is damaged (pic. 3)

• Lifting of persons inadmissible.

• Disorder in the workplace can cause accidents.

• Protect against electric shock. Prevent your body from

coming into contact with earthed parts.

• Check whether your appliance is not damaged.

Carefully inspect safety devices if not faulty or working

improperly before further use of the appliance. Check

whether functions of movable parts are all right,

whether not clogged or damaged. All parts must be

installed correctly so that all appliance conditions were

guaranteed. Any damaged protective device and part

must be professionally repaired or replaced in a

customer service centre unless provided otherwise in

the Operating Instructions. Damaged switches must be

replaced in a customer service centre. Do not use

devices whose switches cannot be on or off.

•

The cable reel electric motor is protected with

a thermal fuse. When the thermal fuse responses,

the cable reel stops. The cable reel can be used

again only after cooled down (app. 5 minutes).

•

Caution: The cable winch is not suitable for

industrial or continuous operation and it may get

switched off after several operating cycles. When

used for industrial purposes, the appliance must be

checked by an expert before being put into

operation for the first time in accordance with the

applicable operating safety regulations.

• Have any damaged part immediately replaced.

• Never take part in any repair (guarantee expiry and risk

taking).

• Do not unnecessarily expose the cable reel to climatic

influences, solar radiation, dust or low temperatures.

•

It is explicitly prohibited that persons stayed

or walked under or in the immediate vicinity of the

hung burdens.

• Your electric cable reel is fitted with a safety

switch. Press the red safety switch in case of

emergency!! If you want to release the safety

switch blocking then turn it by quarter of a turn

clockwise.

•

Attention:

The cable reel has a limit switch that stops the engine if

the drum is just twined around thrice.

Inadmissible operation

The following manners of use are prohibited!

1. Lifting when cable is not hanging vertically.

2. Trying to lift burdens connected to earth.

3. Lifting of burdens hung outside of axis of gravity.

4. Swinging with the hung burden when trying to get the

burden outside of the reel axis.

5. Burden lifting or sinking if there are any obstacles in the

burden lifting or sinking path.

6. Leaving the reel with a hung burden unattended.

7. Operating the reel from a place where the entire burden

is not in the visual field of the operating staff

8. Lifting of people

Lifting of burdens with a weight exceeding the

maximum allowed load of the reel.

Using the cable reel in any other than faultless

condition.

Continuous operation: Observe the cycles of

operation specified by the producer to ensure

proper engine work.

Using the lifting limit switch for common lifting

process switch-off.

To eliminate abnormal cable unreeling from the

drum, the hook and hook block must not touch the

floor.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gude GSZ 100-200 55050 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 10,51 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gude GSZ 100-200 55050 Manual

Product: