628675
33
Zoom out
Zoom in
Previous page
1/104
Next page
29
GSF 1700 - 6,5 PS | GSF 1700 - 6,5 PS E | GSF 1700 - 6,5 PS 230E
GB
Check the ground on which the appliance is going to
be used and remove any items that might be caught or
thrown o by the appliance.
Wear gloves, protective glasses, closetting winter
clothes and solid shoes with a rough sole when wor-
king and providing maintenance.
Fuel is highly ammable.
Keep the fuel in suitable containers only.
The appliance may only be refuelled outdoors and
not near open re or burning cigarettes.
Refuel before starting the appliance. If the engine
is running or still hot, it must not be refuelled or
the tank cover opened.
Make sure the fuel does not overow. If the
fuel overows, the engine must not be started.
Remove any dirt from the appliance and prevent
any attempt at ignition until fuel fumes have
evaporated.
Use a grounded socket with three wires for all units
with electric driving engines or electric starters.
Set the working screw height so that it does not
touch the surface with rubble or road metal.
Do not adjust the appliance when the engine is
running (except for settings directly recommended by
the manufacturer).
Snow should be removed only after adjusting the snow
blower to the outdoor temperature when there are
extreme temperature dierences. Immediate snow
removing could lead to premature wear of the drive
shaft and other extensions such as the rubber ap.
There is a risk of items being thrown o at eyes when
working with power appliances.
Protective glasses or a shield should always be used
when operating, adjusting or repairing the appliance.
Do not put your hands and legs near the rotating
parts. Keep a safe distance from the eject hole.
Be extremely careful when running over or removing
snow o brash entrances, footpaths and paths. Be
prepared for unexpected risks or moving vehicles.
When you hit a foreign item, switch the engine o,
disconnect the cable from the spark plug and check
thoroughly the snow blower for any damage and
remove it if necessary – the snow blower can be put
into operation again and worked with now.
If the appliance starts abnormally vibrating, switch
the engine o and search for the cause immediately.
Generally, vibrations are a warning against operating
failure.
Switch the engine o every time you stop operating
the appliance, clean the working screw/rotor can/
eject tube and when executing repairs, adjusting and
inspecting the appliance..
When cleaning, repairing and checking the appliance,
make sure that the working screw/rotor and all mo-
ving parts are stopped.
Pull the cable out of electric motors.
Never use the appliance inside rooms; to be used
outdoors only.
Do not remove snow across slopes. Be extremely care-
ful when changing movement direction on slopes.
Never try to remove snow on steep slopes.
Never use the snow blower when guards, sheets
and other protection components are not installed
properly.
Never use the snow blower near glass surfaces, cars,
windows, pits, etc.; set the eject tube angle properly.
Children and pets must be in a sucient distance
from the appliance.
Do not overload the appliance; do not try to remove
snow too quickly.
Never use the appliance at a high travelling speed on
a slippery surface. Be careful when reversing.
Never aim the eject tube at bystanders. Do not allow
anyone to stand before the appliance.
Disconnect the working screw/rotor drive when the
snow blower is to be transported or when not being
used.
Use only extensions and accessories approved by the
snow blower manufacturer (e.g. wheel weights, counter-
weight, cabins, etc.).
The snow blower must only be used when appropri-
ate visibility or good lighting is provided. Stand fast
on the ground and hold the handle tight by hands at
all times. Walk, never run.
Do not allow anybody to stand on the appliance.
Switch the engine o and unplug it if you are not
working with the appliance or when leaving the
appliance or adjusting, maintaining or repairing it.
The appliance should only be used when in a perfect
state. Carry out a visual inspection before swit-
ching the appliance on. Check especially the safety
equipment, electrical control elements, power lines
and screw couplings for any damage and if they
are tightened appropriately. Replace any damaged
parts before the appliance is put into operation if
necessary.
Put the appliance out of operation and store it in a
closed room only after the engine has cooled down.
The engine must necessarily be lled with engine oil
ENGLISH
Güde Motor-Schneefräse 1700_1.4_E-Nummer 2.indd 29 10.08.12 16:53
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude GSF 1700 - 6.5 PS 230E 94583 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude GSF 1700 - 6.5 PS 230E 94583 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 11,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info