624773
39
Zoom out
Zoom in
Previous page
1/108
Next page
35
GB
ENGLISH
Failure removal
Before rectifying a fault on the machine, switch o the machine and pull out the mains plug.
Failures
Causes
Removal
Machine does not work
or stops suddenly
• Power cut
• Motor or switch defective
• Check microswitch
• Check fuse, check overload switch on
machine.
• Have the motor or switch checked by
an electrician.
• Fit the chip extractor hood so that the
microswitch is pressed.
2
Machine stops during
planing
• Planing blade blunt/worn
• Overload switch has tripped
• Check microswitch
• Replace or sharpen blade
• Switch on the motor again once it has
cooled
• Fit the chip extractor hood or bench
lock so that the microswitch is pressed.
2
Workpiece jams during
thicknessing
• Cutting depth too great • Reduce cutting depth and machine
the workpiece in several passes
Unsatisfactory surface
nish
• Planing blade blunt/worn
• Planing blade lled with chips
• Uneven feed
• Replace or sharpen blade
• Remove chips
• Feed the workpiece with constant
pressure and at reduced speed
Machined surface too
rough
Workpiece contains too much
moisture
• Dry workpiece
Machined surface cracked Workpiece was machined against the
grain
Too much material planed at one pass
• Machine the workpiece from the
opposite direction
• Machine the workpiece in several
passes
Workpiece speed too low
during thicknessing
Workpiece was machined against the
grain
Too much material planed at one pass
• Clean bench top and apply a thin
coating of lubricant wax
• Repair transport rollers
• Set the lever for the thicknessing
setting to the top position
Enable and check all safety equipment after all troubleshooting work.
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude GADH 254-230 V 55058 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude GADH 254-230 V 55058 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info