624538

Gude DHH 1050-7 TCW 01996 Manual

15
Zoom out
Zoom in
Previous page
1/65
Next page
4. Align the fixation bolt and nut so that the splitting cross is drawn upwards.
5. Secure the end position by a screwdriver and tighten it.
Area of use
The appliance may only be used for splitting firewood. The split material must have the following dimensions:
- Minimum diameter: 120 mm
Maximum diameter: 300 mm
- Splitting wood along fibres is allowed only.
- Risk of split wood getting squeezed.
- The squeezed piece of wood can be released by tapping the log.
- Cutting the split log out is prohibited!
Split wood length setting
Depending on the splitter type, various wood lengths may be split:
Operation
1. Start the engine by pressing the green switch button. CAUTION! Make sure the engine rotation direction is appropriate for the
400 V option!
2. Keep the feeder cable as short as possible for the 230 V models and choose as big cross section as possible.
3. When the temperature is low, let the splitter run idle for app. 15 minutes to enable the oil to warm up to an appropriate
temperature.
4. Put the split material on the table and hold it using the clamping plates on the lever.
5. Splitting will start by pressing both levers down.
6. After splitting is finished, lift at least one lever and the splitter post will automatically go up.
Operating the log splitter by two persons with one holding the wood and the other pressing the camping plates is strictly
prohibited. Blocking the lever (camping plate) is also prohibited.
Lift setting
The operating power may be increased by shortening the splitting knife
backward movement for logs smaller than app. 50 cm and if there are more logs.
Proceed as follows:
Put a short log on the splitter table and lower the splitting knife to app. 2 cm
above the log.
Switch the splitter off (red button on the switch and unplug the appliance). Now
you can shorten the backward movement using a side-attached rod by fixing the
rod in the required position using the adjusting screw.
4
5
15
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude DHH 1050-7 TCW 01996 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude DHH 1050-7 TCW 01996 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info