624533

Gude DHH 1050-7 T MBS Manual

37
Zoom out
Zoom in
Previous page
1/57
Next page
GB
5
5. Area of Use
The machine is approved for wood processing only. The material to be cleaved shall be of dimensions as follows:
-
Minimum diameter: 120 mm
Maximum diameter: 300 mm
-
Wood is permitted to be cleaved in the direction of grain only.
-
There is a risk of jamming of branchy wood while being cleaved .
-
The jammed pieces may be knocked/banged out
-
Never cut it out with a saw !
Cleaving Length Set-up
Various length of wood pieces may be cleaved:
Type DHH 1050/6 TC
Cleaving length ca 1050/810/560 mm.
6. Operation
Start the motor following the directions in the manual.
1. At low temperature, let the motor idle for about 15 minutes for the oil to get warmed up.
2. Lay a piece of wood to be cleaved on the table and hold it to the lever using anchoring wires/grabs☺.
3. Start cleaving pushing both the levers downward.
4. With cleaving completed, lift one lever at least, the cleaving column will go up automatically.
It is strictly forbidden for two persons operate the machine at a time, when one would hold the wood and the
other one would operate the wires/grabs. Never block the lever (anchoring wire/grab).
7. Lift Setting
With pieces up to ca 50 cm long or a bigger quantity, it is possible to
increase the working capacity by making the cleaving knives reverse
shorter.
Model DHH 1050/6TC with control rods
Procedure is as follows:
Lay a short piece of wood on the table, lo
wer the knife down to be at a
distance of ca 2 cm above the piece and put the machine off. Now, you
may adjust the reverse using the side rods fixing the rod at a required
height with an adjusting screw.
… 37 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude DHH 1050-7 T MBS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude DHH 1050-7 T MBS in the language / languages: English, German, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info