626217

Gude BLACKLINE BL 560 E 95305 Manual

15
Zoom out
Zoom in
Previous page
1/63
Next page
FUEL TANK CAP
thrown up but ground by the cutting knives and the grass
will remain as surface fertilisation on the lawn
2. Cutting and collecting
The grass is collected to the grass catcher (if the grass
is damp or wet it reduces the catcher capacity). If you
want to mount the catcher to the mower lift the cover
plate and hang the grass catcher.
3. Cutting (without grass catcher)
The cut grass is laid in strips.
4. Cutting (side ejection)
Hewed long grass lies down in the strips. Loose screw (Fig.
1/15), pull part of side ejection out and then screw. (Fig. 1/15)
tighten again (Fig. 6)
Changeover to mulching
1. Assembly and disassembly of accessories must always
take place when the engine is switched off.
2. Remove the grass catcher, insert the mulching wedge to
the ejection channel and lock the mulching wedge (1) point it
against two outlets (2) in the bottom part and ensure it with a
self-securing hook (3).
3. Please make sure the mulching wedge is mounted firmly
after the changeover.
4. Attention!!! Use original equipment from the producer
only.
5. Disassembly
Press with thumb in the middle (3) then release and deflect
the mulching wedge downwards.
Attention!!!
If the mower is blocked during mulching reduce the
travelling speed so that the knife could continue in
grinding the grass and spread it on the lawn. Never
remove the gathered grass with your hands.
DRIVE CONTROL
The self-propelling travel is controlled as follows: Press the
lever for automatic stopping (12) towards the handle and
simultaneously press the drive lever towards the handle (13).
The forward movement is stopped by releasing the drive lever
(13).
CUTTING HEIGHT ADJUSTMENT
Depending on the cutting height required it is necessary to
adjust the height of wheels. Adjust the height with the lever (8)
as you wish. The middle position is most suitable at most
mowers.
ADD OIL BEFORE STARTING
The oil level needs to be checked before each use. Fill up oil
as needed (500ml SAE30 engine oil).
OIL FUNNEL CAP – OIL DIPSTICK
The mower is supplied without oil in the engine.
WARNING: Be careful not to overfill the engine with oil,
failing which the absorber would smoke when starting.
1. Make sure the mower stands on a flat surface.
2. Take out the oil tank cover.
3. Insert the oil dipstick and fix it.
IMPORTANT:
• The oil level needs to be checked before each use. If
necessary, add oil to the marking on the oil dipstick.
• The oil must be changed after 25 hours of operation or
each season. At works in a dusty or polluted environment
the oil may need to be changed more often. See “ OIL
CHANGE ” in the Maintenance article in these operating
instructions (SAE 30).
FUEL ADDING (unleaded petrol)
• The fuel is added through the filling hole in the tank.
Pay attention not to spill the petrol. Use common
clean unleaded petrol. Do not mix the petrol with oil.
Always buy only reasonable volume of petrol so that
you could consume it within 30 days.
WARNING: Wipe any spilled oil or petrol. Do not
store, pour, use near open fire.
15
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude BLACKLINE BL 560 E 95305 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude BLACKLINE BL 560 E 95305 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info