626218
13
Zoom out
Zoom in
Previous page
1/54
Next page
4. Cutting (side ejection)
5. Hewed long grass lies down in the strips. Loose screw
(Fig. 1/15), pull part of side ejection out and then screw.
(Fig. 1/15) tighten again (Fig. 5)
Changeover to mulching
1. Assembly and disassembly of accessories must always
take place when the engine is switched off.
2. Remove the grass catcher, insert the mulching wedge to
the ejection channel and lock the mulching wedge (1) point it
against two outlets (2) in the bottom part and ensure it with a
self-securing hook (3).
3. Please make sure the mulching wedge is mounted firmly
after the changeover.
4. Attention!!! Use original equipment from the producer
only.
5. Disassembly
Press with thumb in the middle (3) then release and deflect
the mulching wedge downwards.
Attention!!!
If the mower is blocked during mulching reduce the
travelling speed so that the knife could continue in
grinding the grass and spread it on the lawn. Never
remove the gathered grass with your hands.
DRIVE CONTROL
The self-propelling travel is controlled as follows: Press the
operation lever (lever for automatic stopping) (12) towards the
handle and simultaneously press the drive lever towards the
handle (13).
The forward movement is stopped by releasing the drive lever
(13).
CUTTING HEIGHT ADJUSTMENT
Depending on the cutting height required it is necessary to
adjust the height of wheels. Adjust the height with the lever (8)
as you wish. The middle position is most suitable at most
mowers.
ADD OIL BEFORE STARTING
The oil level needs to be checked before each use. Fill up oil
as needed (500ml SAE30 engine oil).
FUEL ADDING (unleaded petrol)
The fuel is added through the filling hole in the tank.
Pay attention not to spill the petrol. Use common
clean unleaded petrol. Do not mix the petrol with oil.
Always buy only reasonable volume of petrol so that
you could consume it within 30 days.
WARNING: Wipe any spilled oil or petrol. Do not
store, pour, use near open fire.
WARNING: Alcohol-enriched fuels (gasohol) or fuels with
ethyl alcohol or methanol mixtures may attract humidity and
subsequent acid formation. The clean petrol may as a result
of long storage damage the engine fuel system. If you want
to prevent engine problems you should empty the fuel
system before storing for more than 30 days. Empty the fuel
tank, start the engine and let it run until the fuel system and
carburettor are empty. Add fresh fuel each season. See the
storing instructions, too. Never pour cleaners to the fuel tank
to clean the engine or carburettor. By doing so, you could
cause irreparable engine damage.
ENGINE STARTING
At starting first make sure the spark plug is in its place and
there is sufficient amount of oil and petrol in the device.
CAUTION: The engine may smoke at first starting due
to protective oil film on the inner engine surface.
Consider this as normal.
1. Press the operation lever (automatic switching off
lever) (8) to the mobile handle (1).
2. With the operation lever (automatic switching off lever)
(8) pulled in slowly pull out the starting cord (6), when
you feel slight resistance strongly pull in the starter until
the engine is started.
V
ERSCHLUSS DES
KRAFTSTOFFTANKS
FUEL TANK CAP
Picture for engine starting
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude BLACKLINE BL 560 BS 95310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude BLACKLINE BL 560 BS 95310 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info