Manual Gude BLACKLINE BL 460 BS 95315 (page 12 of 50) (English, German, Dutch, French, Italian)

626219

Zoom out

Zoom in

1/50

Area of use

Cutting and collection

Grass is collected to the grass catcher (catcher capacity is

reduced if grass is moist or wet). To fasten the grass catcher

to the mower, lift the cover plate and fit the grass catcher.

Cutting (without grass catcher)

The cut grass is left in stripes.

GAS CONTROL

Self-propelled movement is controlled as follows: press the

automatic switch-off clip (9) towards the handle and the gas

lever (10) towards the handle at the same time.

To stop the forward movement, release the gas lever (10).

CUTTING HEIGHT ADJUSTMENT

The wheels height must be adjusted depending on the required

cutting height. Using the lever (8), adjust the height as required.

The medium position is ideal for most of the mowers.

ADDING FUEL (unleaded)

Fuel is added through the filling hole in the tank. Make sure

fuel is not spilled. Use common pure unleaded fuel. Mix the

fuel with oil. Buy only adequate fuel volume so that it can be

consumed within 30 days.

WARNING: Spilled oil or fuel to be wiped off. Not to

be stored, spilled, used near open fire.

WARNING: Alcohol-enriched fuels (gasohol) or fuels with

ethyl alcohol or methanol mixtures may attract humidity and

subsequent acid formation. Due to long storing, pure fuel may

damage the engine fuel system. To prevent engine problems,

you should empty the fuel system before storing the appliance

for more than 30 days. Empty the fuel tank, start the engine

and let it run until the fuel system and carburettor are empty.

Add fresh fuel each season. See the storing instructions, too.

Never pour cleaners to the fuel tank to clean the engine or

carburettor. By doing so, you could cause irrevocable engine

damage.

STARTING THE ENGINE

When starting the appliance, first make sure the spark plug is

in place and there is sufficient amount of oil and fuel in the

appliance.

Caution: The engine may smoke when the appliance is started

for the first time, which is caused by the protective oil film on the

inside surface of the engine. Take this as normal.

1. Press the primary pump (11) 3-5 times.

2. Press the brake clip (9) towards the sliding handle

(1).

3. With the brake clip (9) engaged, pull out slowly the

starting cord (9) until you can feel slight resistance and then

pull strongly the starter until the engine starts.

Caution: The first steps may need to be repeated several

times in cold weather or when the appliance has not been

operated for a long time.

STOPPING THE ENGINE

To stop the engine, release the brake clip (9).

CAUTION: The knife keeps rotating for a couple of

seconds after the engine has been switched off. To leave

the mower unattended, disconnect the spark plug cap.

Important tips and advice for cutting grass!!!

• Adjusting a bigger cutting height may be necessary under

certain conditions, e.g. grass being too high, to relief the

strain when pushing the mower, remove engine overloading

and prevent grass from getting stuck in the mower. It is

possible that the area will need to be cut more times.

• Vent ports in the grass catcher may get blocked if the catcher

is not cleaned regularly. Clean the grass catcher regularly with

water and let it dry before applying it.

• Keep the upper part of the engine at the starter clean. This will

improve the air flow and increase the engine service life.

• Cut in dry weather only.

• Keep the knives sharp at all times.

SERVICING

IMPORTANT – Regular servicing is absolutely necessary for

constant operational reliability and maintaining the original

appliance performance.

Original spare parts are supplied by the customer service

centre and dealers. An authorised service centre is

recommended to provide the annual servicing and inspection

of the safety elements. Please contact your dealer for

servicing and spare parts.

1) Keep all bolts and nuts tightened to be sure that the

appliance is in an operation-reliable condition. Regular

servicing is necessary to provide safety and trouble-free

operation.

2) Never keep the appliance with fuel in closed rooms as the

evaporating fuel could ignite.

3) It is necessary to let the appliance cool down and empty

the fuel before keeping the mower in closed rooms.

4) To minimise the risk of fire, keep the engine and muffler

and the fuel tank clean and with no grass, leaves and fats.

Do not store the mower with the cut grass.

5) For safety reasons, avoid using the appliance with

any parts that are worn or damaged. Replace any

defective parts with new ones, do not repair them.

Original spare parts and original spare knives to be

used only.

Parts of quality other than specified may damage the

appliance and put your safety at risk.

6) If it is necessary to empty the fuel tank, do it outdoors and

with the engine being cold.

7) Wear solid protective gloves when disassembling and

servicing the knives.

8) Check the appropriate rotating direction and balance of

the knives after sharpening.

9) Check regularly the wear and pollution of the self-closing

cover and grass catcher.

10) Wear safety gloves whenever the appliance needs to be

transported, held in hands or inclined.

At all times, hold the appliance for parts guaranteeing safe

holding. Consider the mower weight and weight distribution.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gude BLACKLINE BL 460 BS 95315 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gude BLACKLINE BL 460 BS 95315 Manual

Product: