642164

Grundig Satellit 700 Manual

3
Zoom out
Zoom in
Previous page
1/40
Next page
Safety Standard Compliance
After service work on a product conforming to the Safety Class II, the
insulating resistance and the leakage current with the product switch
on must be checked according to VDE 0701 or to the specification valid
at the installation location!
This product conforms to the Safety Class II, as identified by the
symbol g .
We recommend that the measurements are carried out using the
METRATESTER 3/4. (Test equipment for checking electrical products
to VDE 0701).
Metrawatt GmbH
Geschäftsstelle Bayern
Triebstr. 44
D 8000 München 50
If the safety of the product is not proved, because
- a repair and restoration is impossible
- or the request of the user is that the restoration is not to be carried
out,
the operator of the product must be warned of the danger by a written
warning.
Recommendation for service repairs
• Use only original spare parts.
With components or assemblies accompanied with the Safety
Symbol S only original-spare parts are strictly to be used.
• Use only original fuse value.
• Safety compliance, parts of the product must not be visually
damaged or unsuitable. This is valid especially for insulators and
insulating parts.
• Mains leads and connecting leads should be checked for external
damage before connection. Check the insulation!
• The functional safety of the tension relief and bending protection
bushes are to be checked:
• Thermally loaded solder pads are to be suck off and re-soldered.
• Ensure that the ventilation slots are not obstructed.
GB
Sicherheitsbestimmungen
Nach Servicearbeiten ist bei Geräten der Schutzklasse II die Messung
des Isolationswiderstandes und des Ableitstromes bei eingeschalte-
tem Gerät nach VDE 0701 / Teil 200 bzw. der am Aufstellort geltenden
Vorschrift, durchzuführen!
Dieses Gerät entspricht der Schutzklasse II, erkennbar durch das
Symbol g .
Wir empfehlen die Messungen mit dem METRATESTER 3/4 durch-
zuführen. (Meßgerät zur Prüfung elektrischer Geräte nach VDE
0701).
Metrawatt GmbH
Geschäftsstelle Bayern
Triebstr. 44
D 8000 München 50
Ist die Sicherheit des Gerätes nicht gegeben, weil
- eine Instandsetzung unmöglich ist
- oder der Wunsch des Benützers besteht, die Instandsetzung nicht
durchführen zu lassen,
so muß dem Betreiber die vom Gerät ausgehende Gefahr schriftlich
mitgeteilt werden.
Empfehlungen für den Servicefall
• Nur Original - Ersatzteile verwenden.
Bei Bauteilen oder Baugruppen mit der Sicherheitskennzeichnung
S sind Original - Ersatzteile zwingend notwendig.
• Auf Sollwert der Sicherungen achten.
• Zur Sicherheit beitragende Teile des Gerätes dürfen weder beschä-
digt noch offensichtlich ungeeignet sein.
• Dies gilt besonders für Isolierungen und Isolierteile.
• Netzleitungen und Anschlußleitungen sind auf äußere Mängel vor
dem Anschluß zu prüfen. Isolation prüfen!
• Die Funktionssicherheit der Zugentlastung und von Biegeschutz-
Tüllen ist zu prüfen.
• Thermisch belastete Lötstellen absaugen und neu löten.
• Belüftungen frei lassen.
D
Attention: Priere d`observer les prescriptions de securite
VDE 701 (concernant les reparations) et VDE 0860 / IEC 65
(concernant le type de produit)!
Composants répondant aux normes VDE ou IEC. Les rem-
placer uniquement par des composants ayant les memes
spécifications.
Lors de la manipulation des circuits MOS, respecter les
pescriptions MOS!
Atención: Recomendamos las normas de seguridad VDE u
otras normas equivalentes, por ejemplo: VDE 701 para
reparaciones, VDE 0860 / IEC 65 para aparatos!
Componentes que cumplen las normas VDE/IEC. En caso
de sustitución, emplear componentes con idénticas especi-
ficaciones!
Durante la reparacion observar las normas sobre com-
ponentes MOS!
Attention: This set can only be operated from AC mains of
120 V/60 Hz. Also observe the information given on the rear
of the set.
CAUTION-for continued protection against risk of fire re-
place only with same type fuses!
CAUTION: to reduce the risk of electric shock, do not remove
cover (or back), no user-serviceable parts inside, refer
servicing to qualified service personnel. Observe MOS
components handling instructions when servicing!
Achtung: Bei Eingriffen ins Gerät sind die Sicherheitsvor-
schriften nach VDE 701 (reparaturbezogen) bzw. VDE 0860
/ IEC 65 (gerätebezogen) zu beachten!
Bauteile nach IEC- bzw. VDE-Richtlinien ! Im Ersatzfall nur
Teile mit gleicher Spezifikation verwenden!
MOS - Vorschriften beim Umgang mit MOS - Bauteilen
beachten!
Attention: Please observe the applicable safety require-
ments according to VDE 701 (concerning repairs) and VDE
0860 / IEC 65 (concerning type of product)!
Components to IEC or VDE guidelines! Only use compo-
nents with the same specifications for replacement!
Observe MOS components handling instructions when ser-
vicing!
Attenzione: Osservarne le corrispondenti prescrizioni di
sicurezza VDE 701 (concernente servizio) e VDE 0860 / IEC
65 (concernente il tipo di prodotto)!
Componenti secondo le norme VDE risp. te IEC! In caso di
sostituzione impiegare solo componenti con le stesse carat-
teristiche.
Osservare le relative prescrizioni durante, lavori con compo-
nenti MOS!
V
D E
!
!
!
V
D E
V
D E
!
V
D E
V
D E
!
!
U.S.&
Canada
USA
D
GB
I
F
E
Sicherheitsvorschriften/Safety requirements/Prescrizioni de sicurezza/Prescriptions de sécurité/
Prescripciones de seguridad
Allgemeine Hinweise General Notes
Satellit 700 Allgemeine Hinweise / General Notes
GRUNDIG Service-Technik
3
3 …


Need help? Post your question in this forum.

Forumrules
1

Forum

grundig-satellit-700

Reset search

  • hello, is that the service manual or the user manual ? thanks. Submitted on 16-3-2023 at 19:01

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig Satellit 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig Satellit 700 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 2,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info