ENGLISH
29
OVERVIEW ______________________________________________________
Additional information for units sold in the UK.
Units sold in the UK are suitable for operation from a 240V ac, 50Hz mains supply.
The range of multi-system receivers is built to work in most European countries. However, the
mains plug and socket system for the UK differs from many European countries.
This appliance has been supplied with a fitted, non-removable, approved converter plug for
use in the UK. This converter plug is fitted with a 5A rated fuse.
In case this appliance is supplied with a moulded 2-pin Euro plug only, which is unsuitable for
UK operation, this must be cut off and immediately disposed of. An approved 13A, 3-pin UK
plug should then be fitted by a qualified electrician.
Note:
The severed Euro plug must be destroyed to avoid a possible shock hazard should it be
inserted into a socket elsewhere.
If a non-rewireable 3-pin plug or a rewireable 13A (BS1363) 3-pin plug is used, it must be
fitted with a 5A ASTA or BSI approved BS1362 fuse. If any other type of plug is used it must
be protected by a 5A fuse either in the plug, or at the distribution board. If this type of plug
becomes defective, ensure that the fuse is removed before disposal, to eliminate potential
shock hazard.
If it is necessary to change the fuse in the non-rewireable plug, the correct type and rating
(5A ASTA or BSI approved BS1362) must be used and the fuse cover must be refitted. If the
fuse cover is lost or damaged, the lead and plug must not be used until a replacement is
obtained. Replacement fuse covers should be obtained from your dealer.
Important:
The wires in the mains lead are colour coded in accordance with the following code:
BLUE – NEUTRAL
BROWN – LIVE
As the colours of the wires in the mains lead of your appliance may not correspond with the
coloured marking identifying terminals in your plug, proceed as follows:
Connect the BLUE coloured wire to plug terminal marked with the letter “N” or coloured
black.
Connect the BROWN coloured wire to the plug terminal marked with the letter “L” or colou-
red red.
In no circumstance must any of the wires be connected to the terminal marked with the letter
“E”, earth symbol “
z”, coloured green, or green & yellow.
Replacement mains lead sets can be obtained from your local dealer, or by contacting Grun-
dig Consumer Relations (01788 570088)
Moulded 3-pin lead set, suitable for UK use:
Ref: Leadset UK 8290-991-224
Moulded 2-pin Euro lead set, not suitable for UK use:
Ref: Leadset Euro 8290-991-316
