ENGLISH
9
IMPORTANT INFORMATION
___________________________________________________
Remote control of external devices
For technical reasons it may happen in exceptional cases that an external device
(video recorder, DVD player or similar) does not correctly respond to the
remote control commands.
If this should be the case, change the position of the external device, or change
the batteries in the remote control of the external device.
Display of a VGA picture
Check and correct if necessary the VGA mode setting on your PC
(640 x 480/60Hz, 640 x 400/70Hz, 640 x 350/70Hz).
To ensure an optimum picture quality, use only a correctly shielded VGA cable
(e.g. ferrite core) for a cable length above two meters.
When using a laptop:
In addition to checking the resolution setting, make sure that the laptop has been
set for operation with an external video source (moitor).
Additional Information for Units sold in Great Britain
Units sold in GB are suitable for operation from a 240 V AC, 50 Hz mains supply.
In case this appliance is supplied with a Safety Standard Approved mains lead fitted with a non-rewireable 13 Amp mains
plug which, if unsuitable for your socket, should be cut off and an appropriate plug fitted by a qualified electrician. The fuse
and fuse holder must be removed from the plug as accidental insertion of the redundant plug into a 13 Amp socket is likely
to cause an electrical hazard.
Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13 Amp socket else-
where.
If it is necessary to change the fuse in the non-rewireable plug, the correct type and rating (5 Amp ASTA or BSI approved BS
1362) must be used and the fuse cover must be refitted. If the fuse cover is lost or damaged the lead and plug must not be
used until a replacement is obtained. Replacement fuse covers should be obtained from your dealer.
If a non-rewireable plug or a rewireable 13 Amp (BS 1363) plug is used, it must be fitted with a 5 Amp ASTA or BSI appro-
ved BS 1362 fuse. If any othe type of plug is used it must be protected by a 5 Amp fuse either in the plug or at the distributi-
on board.
Important:
The wires in the mains lead are coloured in accordance with the follow-ing code:
BLUE – NEUTRAL
BROWN – LIVE
As the colours of the wires in the mains lead of your appliance may not correspond with the coloured marking identifying the
terminals in your plug, proceed as follows:
Connect the BLUE coloured wire to plug terminal marked with the letter "N" or coloured black.
Connect the BROWN coloured wire to the plug terminal marked with a letter "L" or coloured red.
In no circumstance must any of the wires be connected to the terminal marked with a letter "E", earth symbol , coloured
green or green and yellow.
Replacement mains lead can be obtained from your dealer.
