26
General information
Disabling the buttons
1 Use »
t
/
t
x
« on the bottom of the device to disable the buttons.
– Display: »t «.
Note:
The volume adjustment, reception sensitivity and the alarm signal selection
are not disabled.
2 Use »
t
/
t
x
« on the bottom of the device to enable the buttons.
– Display: »t « disappears from the display.
Deleting all settings
Interrupt the power supply for at least 2 minutes to reset the device to its
original state. All settings are lost when you do this.
1 Remove all the batteries – including the back-up batteries.
2 Pull out the mains adapter and wait for at least 2 minutes before
plugging it in again.
– The time, alarm time and radio settings are deleted.
Information
This device is noise-suppressed according to the applicable EU directives.
This product fulfils the European directives 89/336/EEC, 73/23/EEC and
93/68/EEC.
This device conforms to the safety regulation DIN EN 60065 (VDE 0860)
and therefore the international safety regulation IEC 60065.
Technical data
Power supply:
Mains adapter: 6 V, 50/60 Hz
Battery operation: 4 x 1.5 V, LR6/AM3/AA
Back-up batteries: 2 x 1.5 V, LR3/AM4/AAA
Output: DIN 45324, 10 % THD 400 mW
Frequency band: FM 87.5 ...108.0 MHz
MW 522 ... 1620 kHz
LW 144 ... 281 kHz
SW 5.95 ... 15.6 MHz (49 ... 19 m)
Dimensions and weight: W x H x L 210 x 115 x 63 mm
Weight approx. 550 g
Technical and design modifications reserved.
OPERATION
_______________________________________________
1
.
06
3
M
t
FM
MHz
0