4
The Remote Control
Inserting batteries into the remote
control
Press the catch and remove the cover from the bat-
tery compartment.
Insert the batteries (2 x 1.5 V, type Micro RO3P).
w
!
Observe correct polarity; marked on the bottom of
the battery compartment.
w
!
If your recorder no longer responds correctly to the
remote control commands, the batteries may be
exhausted.
Exhausted batteries must be removed.
The manufacturer cannot be held responsible for
damage resulting from battery leakage.
Exhausted batteries must be handed over to a spe-
cial waste collecting point (environmental protec-
tion).
The two levels of the remote
control
The buttons on the remote control are located on
two separate levels.
The buttons that are required for essential opera-
ting functions are located on the upper level.
The buttons that are required for convenience func-
tions are located on the level under the cover flap.
2
➡
At a glance
The buttons on the remote control are explained
briefly on this page and the following page.
For operation please see the respective chapter of
these operating instructions.
❒
Buttons for TIMER programming
A Switches the recorder off (stand-by).
B PROG. Selects the TV station.
B
DAY Selects the day.
B
START Selects the start time.
B STOP Selects the stop time.
¢
SET/CHECK Calls up the »Record Programming«
table for checking, and for altering
data.
¢
CLEAR Deletes data.
¢
ON/OFF Interrupts/activates TIMER recor-
ding.
PROG.