755989

Grundig GRB 3000 BT Manual

18
Zoom out
Zoom in
Previous page
1/70
Next page
ENGLISH
18
7
Prolonged listening at loud volumes with
the earphones can damage your
hearing.
7
The only way to completely disconnect the device
from the mains is to unplug the mains cable.
General information on laser devices
You will find a symbol similar to the one shown here
on the bottom of the device.
CLASS 1 LASER PROD-
UCT means that the la-
ser is designed in such
a way as to ensure that
the maximum permis-
sible emission value cannot be exceeded under any
circumstances.
If operating devices or methods other than those speci-
fied here are employed, it may lead to dangerous ex-
posure to emissions.
Invisible laser radiation is emitted if the CD compart-
ment is opened and the safety locking mechanism is
shorted. Do not expose yourself to this radiation.
To ensure that this device provides you with long-term
satisfaction and enjoyment, please observe the follow-
ing instructions.
7
This device is designed for the playback of audio
signals. Any other use is expressly prohibited.
7
Protect the device and the CDs from rain, moisture
(dripping or splashing water), sand and heat. Do not
leave it next to heaters or inside parked cars in the
sun.
7
Make sure there is adequate ventilation when posi-
tioning the device. There must be a free space of at
least 10 cm behind the device. Do not place objects
on the ventilation slots.
7
Do not place any objects containing liquids (for ex-
ample, vases) on the device. Do not insert any for-
eign bodies in the CD compartment of the device.
7
Do not place any objects such as burning candles
on the device.
7
Bringing the device in from the cold can cause con-
densation on the CD lens, which prevents it from
playing. Give the device time to warm up.
7
Only use the device in a moderate climate.
7
The CD unit contains self-lubricating bearings, which
must not be oiled or greased.
7
Thunderstorms are a danger to all electrical devices.
Even if the device is switched off, it can be damaged
by a lightning strike to the mains. Always remove the
mains plug during an electrical storm.
7
If malfunctions occur due to static electricity charges
or fast transient (burst), reset the device. To do this,
pull out the power plug and connect it again after
a few seconds.
7
Do not use any cleaning agent, as this may dam-
age the casing. Clean the device with a clean, moist
leather cloth.
7
Please note when deciding where to put the
device that furniture surfaces are covered by
various types of lacquer and plastic, most of which
contain chemical additives. These may cause corro-
sion to the feet of the device, thus resulting in stains
on the surface of the furniture which can be difficult
or impossible to remove.
7
Never open the device casing under any circum-
stances. No warranty claims are accepted for dam-
age resulting from improper handling.
SAFETY AND SET-UP __________________________
CLASS 1
LASER PRODUCT
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig GRB 3000 BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig GRB 3000 BT in the language / languages: English, German, French, Polish, Spanish as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info