574853

Grundig GDK2382 Manual

9
Zoom out
Zoom in
Previous page
1/16
Next page
9
OPERATION ________________________________
Wall drilling and bracket
fixing
Wall marking:
7
Draw a vertical line on the supporting wall up
to the ceiling, or as high as practical, at the
centre of the area in which the hood will be
installed.
7
Draw a horizontal line at 650 mm above the
hob. Place bracket
6
Screws 2,9 x 9,5 on
the wall as shown about 1-2 mm from the ceil-
ing or upper limit aligning the centre (notch)
with the vertical reference line.
7
Mark the wall at the centres of the holes in
the bracket.
7
Place bracket
6
on the wall as shown at X
mm below the first bracket (X = height of the
upper chimney section supplied), aligning the
centre (notch) with the vertical line.
7
Mark the wall at the centres of the holes in
the bracket.
7
Mark a reference point as indicated at 116
mm from the vertical reference line and 306
mm above the horizontal reference line.
7
Repeat this operation on the other side.
7
Drill ø 8 mm holes at all the centre points
marked.
7
Insert the wall plugs
7
in the holes.
7
Fix the brackets using the
8
(4,2 x 44,4)
screws supplied.
7
Insert the two screws
8
(4,2 x 44,4) supplied
in the hood body fixing holes, leaving a gap
of 5-6 mm between the wall and the head of
the screw.
Mounting the hood body
7
Before attaching the hood body, tighten the
two screws Vr located on the hood body
mounting points.
7
Hook the hood body onto the screws
8
.
7
Fully tighten the support screws
8
.
7
Adjust the screws Vr to level the hood body.
Connections
Ducted Version Air Exhaust
System
When installing the ducted version, connect the
hood to the chimney using either a flexible or
rigid pipe ø 150 or 120 mm, the choice of which
is left to the installer.
7
To install a ø 120 mm air exhaust connection,
insert the reducer flange
9
on the hood body
outlet.
7
Fix the pipe in position using sufficient pipe
clamps (not supplied).
7
Remove possible charcoal filters.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig GDK2382 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig GDK2382 in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info