570228
26
Zoom out
Zoom in
Previous page
1/28
Next page
ENGLISH
4949
Troubleshooting
If a fault occurs, first refer to this information before you take the device for
repair.
If you are unable to rectify the fault using the information given here, contact
your local dealer or service specialist.
Under no circumstances should you attempt to repair the radio recorder
yourself, as this would invalidate the guarantee.
INFORMATION
_______________________________________
PROBLEM
GENERAL
INFORMATION
No sound
The radio recorder
does not respond
when you press the
buttons
RADIO
Poor radio reception
CD
Playback will not start
The CD player skips
tracks
CD-Rs or CD-RWs
are not being played
back, or being
played back
incorrectly
MP3CD plays to past
or slowly
TAPE
Poor cassette play-
back sound quality
No cassette
recording
POSSIBLE CAUSE
The volume setting is too low
The headphones are connected
The batteries are flat
The batteries are incorrectly
inserted
The mains cable is incorrectly
connected
Static electrical discharge
Weak radio antenna signal
Interference from electrical
devices such as televisions,
video recorders, computers,
neon lamps etc.
The CD is damaged or dirty
A stored track memory is being
played
The RANDOM function is
activated
Faulty software or hardware
settings for burning, or the CD
being used is faulty
The sampling frequency of
44.1 kHz was not used
Dust and dirt on magnetic
heads, capstans or idlers
Recording protection tab
has been broken off
REMEDY
Turn up the volume
Unplug the headphones
Replace the batteries
Insert the batteries
correctly
Connect the mains cable
properly
Switch off the radio
recorder, disconnect the
mains cable and plug it in
again after a few seconds
Remove any batteries
VHF (FM): tilt and turn the
telescopicantenna
Switch from stereo to mono
reception
MW and LW: turn the whole
device
Keep the radio recorder
away from electrical
devices
Replace or clean the CD
Switch to normal playback
or delete
Switch off the RANDOM
function
Check the components of
your CD burner/burner
software or change the CD
you are using
Burn a new MP3 CD using
the correct sampling
frequency
Clean the magnetic heads,
capstan and idler
Cover the opening with
adhesive tape
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig FREAXX 50 RRCD 4305 SPCD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig FREAXX 50 RRCD 4305 SPCD in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Grundig FREAXX 50 RRCD 4305 SPCD

Grundig FREAXX 50 RRCD 4305 SPCD User Manual - German - 27 pages

Grundig FREAXX 50 RRCD 4305 SPCD User Manual - Dutch - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info