34
INFORMATION
___________________________________________
Rectifying minor problems
If a fault occurs, first refer to this information before you take the digital
receiver for repair.
If you are unable to rectify the fault using the information given here, contact
your local dealer or service specialist.
Under no circumstances should you attempt to repair the digital receiver
yourself, as this will invalidate the guarantee.
PROBLEM
No function, mode
indicator not lit
No picture
No sound
Message: »Faulty
signal«
The remote control
does not work.
The time is not
correctly displayed
Message: »Short
circuit or overload at
the antenna input«
POSSIBLE CAUSE
Power cord incorrectly
connected
Euro-AV (Scart) cable not
properly connected, incorrect
settings in the
»Device connections« menu
The sound is muted, the
Euro-AV cable is incorrectly
connected or the receiver
volume is set to low
The antenna is not properly
connected or positioned
No batteries are inserted,
or they are low, or the remote
control is not directed at the
infrared sensor
Deviation from the local time
The antenna has an excessive
current consumption or a short
circuit.
REMEDY
Connect the power cord
correctly
Connect the Euro-AV cable
correctly, correct the menu
settings
Switch on the sound,
connect the Euro-AV cable
correctly, turn up the
volume
Connect the antenna
correctly. Move the antenna
around to find the best
position
Insert the batteries
correctly, put in new
batteries, point the remote
control at the infrared
sensor
Correct the difference
Switch off/unplug the
device immediately.
Disconnect the antenna,
go to the »Channel
search«, set the »Antenna
supply« to »Off« and save
this setting.