ENGLISH
59
INFORMATION
___________________________________________
Troubleshooting
If a fault occurs, first refer to this information before you take the digital
receiver for repair.
If you are unable to rectify the fault using the information given here, contact
your local dealer or service specialist.
Under no circumstances should you attempt to repair the digital receiver
yourself, as this will invalidate the guarantee.
PROBLEM
No function, mode
indicator not lit
No picture
No sound
No picture or sound
on certain stations
Message »Faulty
signal«
The remote control
does not work
The time is not cor-
rectly displayed
Picture interference
on stations with a
frequency around
12480 MHz
POSSIBLE CAUSE
Power cord incorrectly
connected
Euro-AV (Scart) cable not
properly connected, incorrect
settings in the »TV Output«
menu
The sound is muted, the
Euro-AV cable is incorrectly
connected or the receiver
volume is set to low
The station does not broadcast
all day.
The satellite antenna is not
correctly installed, the satellite
cable is damaged, incorrect
settings in the »LNB Setup«
menu
No batteries are inserted, or
they are low, or the remote
control is not directed at the
infrared sensor
Deviation from local time
The interference may be caused
by DECT cordless telephones
near the receiver
REMEDY
Connect the power cord
correctly
Connect the Euro-AV cable
correctly, correct the menu
settings
Switch on the sound,
connect the Euro-AV cable
correctly, turn up the
volume
Find out about the broad-
casting times or try the
station again at a different
time.
Install the satellite antenna
correctly, replace the satel-
lite cable, enter the correct
menu settings
Insert the batteries correct-
ly, put in new batteries,
point the remote control at
the infrared sensor
Correct the deviation
(see page 18)
Take the DECT telephones
away from the receiver and
the satellite cable