ķ
14
Radio
AIM storage capacity
– approx. 3 minutes
➭
page 23, EXPERT setting ´`.
If the AIM memor
y is full the oldest traffic
announcements will be deleted.
AIM memory standby
If the car radio is on
the AIM memory standby is always on when
– a traffic radio station is set;
» TP « is shown in the display and the
–
¡
AIM TP
button is “activated”.
If the car radio is off
– AIM function (on)
➭
page 23: EXPERT setting ´?.
– Before switching off the radio:
Traffic radio station is set: » TP « in the
display and
¡
AIM TP
button is “activated”
– aerial is ready to receive.
– If TIMER is preselected:
switch-on time(s) set.
➭
page 23-24: EXPERT setting ´Q or ´W.
Listen to AIM memory
Press
¡
AIM TP
button briefly; in the display …
Exam
ple
» MO7 O6: 15 «:
– 7 traffic announcements are stored.
– First you will listen to the last (most recent)
traffic announcement (MO7) of 6:15 a.m.
– Successively you will listen to all recordings.
AIM memor
y empty:
» NO MSG « (No Message).
If you want a traffic announcement to be …
– repeated or skipped:
press
¡
<
NEXT
button or
¡
NEXT
>
button briefly.
– “fast forwarded or rewound”:
hold down
¡
NEXT
>
button or
¡
<
NEXT
button.
– “Delete”
AIM memory
While listening to the AIM memory, press
¡
U III
button until signal tone sounds:
In the display » NO MSG « (No Message).
Notes
No AIM memor
y standby with car radio
switched off
if, when switched off, in the display:
» NO AIM «.
If AIM memory is on and car radio is off:
– Traffic announcements that are older than
6 hours are deleted.
– If the car radio is not switched on for one
week with TIMER preselected (set switch-on
times), switching on of the TIMER will be
suppressed until the car radio is switched
on again (current consumption).
Some vehicles, when being exited, indicate
sources of current consumption that have not
been switched off, e.g. lights. This may also
be the case when the AIM memory of your car
radio is in standby mode.
Ask your car dealership whether this applies
to your vehicle and what can be done to reme-
dy this problem. In most cases it is sufficient
to connect connection A7
(+12 V) of the car
radio directly to the battery and
connection A8
(– earth) of the car radio
directly to the vehicle earth.
Line cross-section at least 1,5 mm
2
.
For safety reasons it is imperative that a fuse
holder (with fuse 16 A) is used for connecting
the battery +12 V with connection A7 of the
car radio! The fuse holder should be placed
directly (short cable) at the battery.
