ķ
18
Installation and removal
A5 +12 V switching voltage output
(max. 0.5 A)
Is at blade contact A 5 when the car radio is
switched off.
For automatic aerials (extending/retracting),
aerial amplifiers (operating voltage) etc.
A4 terminal for +12 V ignition voltage
Connect on terminal 15
of the vehicle if you
wish to switch the car radio on and off with
the ignition switch.
The connection A4 can also be left unconnect-
ed. In this case, the radio must always be
switched on and off with the
¡
IO
button.
The unit then does not switch off after one
hour when the ignition is not switched on. The
security LED does not flash.
A2 Phone mute connection
for car phones and radio equipment:
The car radio is muted when a connected car
phone or radio equipment is in operation.
»PHONE« appears in the display, see page 15,
EXPERT settings.
The blade contact A2 from the mute output of
the telephone/radio equipment must be
grounded!
Speakers
Blade contacts B: Figure +
Maximum output power
to 4Ω speakers: 4 x 20 W.
Front speakers Rear speakers
B3 right +B1right +
B4 right –B2right –
B5 left +B7left +
B6 left –B8left –
í
The speakers must not be electronically
connected with each other and must
not be grounded!
Additional connections
Blade contacts C: Figure +
CD changer (AUX connection )
C13 CD bus control line. For AUX mode,
connect with C15.
C15 CD bus, earth.
C16 +12 V supply voltage for CD changer.
C17 Switching voltage for CD changer.
C18 CD-AF/AUX-AF, earth.
C19 CD-AF/AUX-AF, left.
C20 CD-AF/AUX-AF, right.
C7 for service only
C9 for service only
í
The contacts C7 and C9 must remain
free.
