ß` Speed-controlled volume
"SCVOL 124" (- - … 144)
Setting is only possible if a speed-control-
led signal is present on the SCV connection
(A1).
" SCVOL - - " : SCV switched off.
" SCVOL 144 " : maximum effect.
Setting
1. Car standing still, motor running:
set desired volume with
¢¢
rotary knob.
2. Prepare EXPERT setting:
press the
“
LOUD
EXPERT
button until signal
sounds.
Turn
¢¢
rotary knob until e.g.
" SCVOL ..." appears in the display.
Briefly press the
“
LOUD
EXPERT
button:
»
E « appears in the display.
3. At higher speed:
use the
¢¢
rotary knob to set the required
volume, e.g." SCVOL 124 " in display.
Press the
“
LOUD
EXPERT
button until the signal
sounds.
í
For reasons of safety the following
setting should be carried out by the
passenger!
ķ
21
GB
Acoustic system
It is possible to separately adjust the bass and
treble for the rear and front loudspeakers.
The setting can be changed in the range of –3
to
+
3 with the
¢¢
knob.
ßQ Bass – front loudspeakers
”BAS F 0” (F = Front)
ßW Bass – rear loudspeakers
”BAS R 0” (R = Rear)
ßE Treble – front loudspeakers
”TRE F 0” (F = Front)
ßR Treble – rear loudspeakers
”TRE R 0” (R = Rear/hinten)
ßT On/Off switching delay for connected
booster
(booster switching voltage = contact C6)
" BDLY ... " (O6 … 99)
If “switching noise” occurs: increase set
value until switching noise is no longer
audible.
ßZ Activating the coding
If "CODE" appears in the diplay, coding is
not activated.
If "SAFE" appears in the display, coding is
activated.
Your car radio has been designed throughout
to ensure maintenance-free operation over an
extended period of time.
If a malfunction
should occur, please consult your dealer.
In the Federal Republic of Germany, Grundig
car radios can be exchanged by your dealer
on request for a works-tested exchange unit
in the event of a defect occuring.
Please note:
It is a condition for your dealer to participate
in this exchange system that the guarantee
seal on your car radio is not damaged.
Cassettes must not be subjected to high
temperatures (see manufacturer's specifica-
tions) and should be put into their case after
use.
The front panel of the car radio must only be
cleaned with a soft, dust-absorbent, anti-static
cloth. Polishing and cleansing agents may
damage the surface of the trimplate.
The tape head must be free of tape dust in
order to avoid losses in the treble tones
during playback. Therefore you should clean
the tape head with a cleaning cassette after
every 50–100 hours of operation.
Maintenance and Care
EXPERT
