Manual Grouw 17935 (page 134 of 165) (English, German, Danish, Swedish, Norwegian, Finnish)

788791

134

Zoom out

Zoom in

1/165

Step 2: Laying out the boundary wire

Follow your sketch of the garden and lay out the

boundary wire clockwise so that you create “islands”

anticlockwise around any obstacles. Avoid 90 degree

corners. Instead, divide them up in two 45 degree

angles as shown in corner A above.

Use a rubber mallet to secure the boundary wire with a

plastic peg at least once every metre. If the pegs break

or are dicult to knock in because the ground is hard, it

may help to water the lawn rst.

Secure the boundary wire as close to the ground as

possible, preferably right down by the grass roots. The

boundary wire must be taut, and there must be no

gaps under it. It is important that the robot lawnmower

cannot touch the boundary wire with its blades, which

would cut the wire. It is recommended therefore that

the cutting height be set to 60 mm or that the blades

are removed for the test run.

Over the course of a few weeks, the lawn will grow

up around the boundary wire so that you cannot

immediately notice it in the garden.

If you are able to use a scarier or verticutter on the

lawn, you should instead dig the boundary wire down

into a groove no more than 5 cm deep so that it is

protected under the soil surface. Remember to adjust

the scarier or verticutter so that the blades/rakes

cannot reach down to the boundary wire.

The boundary wire can be left on the grass in some

places and under the ground in others, or under paving

stones with a thickness of up to 5 cm.

Obstacles must be enclosed as “islands”

The boundary wire running to and from an island

must be laid quite close together and must be secured

using the same pegs. This ensures that signals from

the boundary wires to and from the island oset one

another so that the robot lawnmower does not register

them as a barrier.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Grouw 17935 in the language / languages: English, German, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 17.87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Grouw 17935 Manual

Product: