505515
14
Zoom out
Zoom in
Previous page
1/21
Next page
Anschlüsse und Einstellungen
FRONT INPUT................. Connexion des câbles RCA, signal entré avant
REAR INPUT................. Connexion des câbles RCA, signal entré arrière
MONO OUTPUT............... Connexion des câbles RCA, signal sortie vers un Amplificateur mono
UNBAL........................... Commutateur pour le signal entré Non Symétrique
BAL............................... Commutateur pour le signal entré Symétrique
FRONT / R-ch................. Sortie Haut parleur avant
REAR / L-ch....................Sortie Haut parleur arrière
REMOTE........................ Connexion du Bass Remote Contrôle
GZUA 4125SQ
GZUA 2125SQ / GZUA 2250SQ
POWER......................... Lampe témoins Bleu si l’amplificateur s’est mis en route
PROT............................ Lampe témoins Rouge si l’amplificateur est en protection
FUSE............................. Porte Fusible N’utilisez pas de fusible avec unité de tension différente.
+12V.............................. Connecteur + 12 Volt Connexion du câble de batterie +12V
REM.............................. Connecteur + Remote Connexion du câble remote de l’autoradio
GND.............................. Connecteur - Masse Connexion du câble Masse
GZUA 4125SQ
GZUA 2125SQ GZUA 2250SQ
Mise en marche de l’amplificateur:
L’amplificateur s’allume automatiquement quelques secondes après la mise sous tension de la Radio.
Attention si votre Amplificateur chauffe ce dernier c’éteint automatiquement et se remet en fonction dés qu la
température revient a la normale.
Pour un bon Fonctionnement de l’amplificateur le Gain doit être bien règle (8V-250mV)
Régler le GAIN du Signal d’entrée (8V-250mV)
Etape 1 Régulateur GAIN avec rotation sur la gauche, positionner sur MIN
Etape 2 Augmenter le Volume de la Radio sur 2/3 du volume maximum
Etape 3 Positionner maintenant le Régulateur GAIN sur un niveau de son agréable à entendre
Avec le Bass Remote vous pouvez réglez le niveau du Subwoofer à l’avant du Véhicule
(GZUA 2225SQ).
Le réglage du BASSBOOST permets de rectifier le réglage entre le grave et le Bas Medium
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ground zero GZUA 2125SQ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ground zero GZUA 2125SQ in the language / languages: German as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info