66440
14
Zoom out
Zoom in
Previous page
1/48
Next page
7
Controls and functions – GZHA 5125XII
8
Controls and functions
1 Speaker terminals For connection of the speakers
2
Power terminals
GND -> Ground connection
REM -> Remote antenna terminal
BATT -> +12 Volt
3 Satus indication
BLUE
OK
RED – Error
4 Cinch inputs
Terminal for connection of the RCA wires.
To avoid failure, please use high quality RCA wires.
5 Input level controlle
r
With this controller you can adjus
t
the input sensitivity.
6
Bass boost controlle
r
(GZHA 2350XII)
For adjusting of the bass boost level in the range from 0 to +12 dB.
7
Bass frequency controlle
r
(GZHA 2350XII)
For adjusting of the bass boost frequency in a range from 30 to 80 Hz.
8
High pass controller
(Subsonic for GZHA 2350XII
and CH 3+4 GZHA 4150XII)
Se
t
the filter switch to „HIGH“ position.
Adjust the variable HPF crossover frequency to the desired frequency
using the controller. All frequency between 5 and 3000 Hz will be
reproduced.
9 Mode switch
A
djust the crossover for the chosen utilization.
LPF – Only bass frequencies (below 30Hz - 250Hz) will be reproduced.
FULL – All frequencies will be reproduced.
HPF – Only middle and high frequencies (over 40 Hz – 3 KHz) will be
reproduced.
GZHA 2350XII / GZHA 4150XII CH 3+4:
At LPF adjustment, also the Highpass (Subsonic) is activated.
This equals a Bandpass filter of 5 – 250 Hz.
GZHA 4150XII CH 1+2
The Lowpass filter is not adjustable. It is fixed at 80 Hz.
10 Low pass controller
For subwoofer and Kickwoofer operation -
Only frequencies from 30 Hz to 250 Hz will be reproduced (depending
on the LPF filter controller position). Set the filter switch to „LOW“
position. Adjust the variable LPF frequency to the desired frequency
using the controller.
GZHA 2350XII / GZHA 4150XII CH 3+4:
At LPF adjustment, also the Highpass (Subsonic) is activated.
This equals a Bandpass filter of 5 – 250 Hz.
11
Phase shift switch
(GZHA 5125XII)
Phase shift controller
(GZHA 2350XII / 4150XII)
This controller allows you to fit the subwoofer channel in-phase to the
front system.
12 Remote control input For connection of the bass remote control.
13
Cinch outputs
(GZHA 4150XII)
For fullrange operation of an additional amplifier.
14 Filter controller
With this controller you can adjust the filter frequency according to
the setting of the mode switch (9).
15
Subsonic controlle
r
(GZHA 5125XII)
For adjusting the subsonic filter in a range from 5 Hz to 50 Hz.
16
Input switch
(GZHA 5125XII)
With this chose if the 5. Channel should be powered by the cinch input
5/6 or the sum of signals from 1/2/3/4.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ground zero GZHA 4150 X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ground zero GZHA 4150 X in the language / languages: German as an attachment in your email.

The manual is 5,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ground zero GZHA 4150 X

Ground zero GZHA 4150 X User Manual - English - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info