759832
11
Zoom out
Zoom in
Previous page
1/66
Next page
8
Activating cleaning mode,
see page 2.
Triggering flushing and signalling status,
see page 2.
*F: Solenoid valve intact / defective
*G: Temperature sensor intact / defective
Making settings, see page 3
Activating setting mode, see Fig [1].
Setting the flow volume, see Fig. [2a] .
Setting the programme, see Fig. [2b].
Observe programme table, see fold-out page I.
Setting mode is automatically terminated after 3 minutes.
Maintenance, see page 4
Demounting ceramic and shut off water supply,
see Fig. [1] and [2].
Inspect and clean all components and replace if necessary.
I. Power supply unit, see Fig. [3]
II. Solenoid valve and filter, see Fig. [4].
III. Siphon with temperature sensor, see Fig. [5].
IV. Electronic, see Fig. [6].
Assamble in reverse order.
Replacement parts
see fold-out page I
Disposal note
Fault / Cause / Remedy
This category of device does not belong in the
domestic waste, but must be disposed of separately
in accordance with the relevant national regulations.
Fault Cause Remedy
Water not flowing Water supply interrupted
Filter in solenoid valve blocked
Solenoid valve defective
Plug-in connector without contact
No voltage
- Power supply unit defective
- Power supply switched off
Outlet clogged
Temperature sensor defective
Through high ambient temperature, the
water temperature in the siphon and in the
water supply is > 35 °C
Flushing during continuous use is activated
(Flushing is initiated every 8 min.
independent of the use)
- Open shut-off valves
- Clean filter
- Replace solenoid valve
- Check plug-in connector
- Replace power supply unit
- Switch on voltage supply
- Clean outlet
- Replace siphon with temperature sensor
- Ensure operating temperature of the water in the
water supply
- After drop of the temperature in the siphon the
elektronic terminates the mode flushing during
continuous use automatically
Undesired water
flow
Automatic flushing activated
Through high ambient temperature, the
water temperature in the siphon is > 35 ° C
Solenoid valve defective
- The elektronic triggers a flushing to reduce the
water temperature in the siphon
- Replace solenoid valve
Flow volume too
low
Solenoid valve defective
Filter in solenoid valve blocked
- Replace solenoid valve
- Clean filter
Bluetooth®
Connection not
possible
No reception/connection interrupted
Interferences in the reception area
Obstacle in transmission path
- Turn back the device to receiving range
- Turn off the source of interference
(observe manufacturer´s documentation)
- Remove from radio path
Interrupted while
operating
Interferences in the reception area
Obstacle in transmission path
- Turn off the source of interference
(observe manufacturer´s documentation)
- Remove from radio path
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grohe 39368 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grohe 39368 in the language / languages: All languages as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info