632801
12
Zoom out
Zoom in
Previous page
1/28
Next page
Page 11 Espressimo 2450 & 1750 Espresso Cappuccino Machines
Care and Cleaning
Monthly Cleaning
Clean Group Head, Screen and Group
Head Gasket
1. Remove screw holding screen in place.
2. Remove and clean screen, shower, and group
head gasket.
3. Wipe and clean group head.
4. Reinstall gasket, shower, and screen, and then
tighten screen securely.
(Note: There are numbers molded onto one side of the
gasket. Insert gasket with numbers facing up.)
Make sure gasket is positioned in place.
Yearly Cleaning
Inspection, testing, and repair of this espresso
machine, including the following procedures should
only be performed by a qualified service technician.
Replace head gaskets annually.
Clean group strainer, replacing if necessary.
Flush heat exchanger by running water through the hot water
spout and check for proper flow.
Check steam pressure to be approximately 17-20 P.S.l.
Check group head pressure to be approximately 125 P.S.I.
Empty the Boiler
The following is proper procedure for emptying and
replacing water in the boiler.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Clean Pump Strainer
1.
2.
3.
4.
5.
6.
Plug in. Make sure boiler is filled ("AUTOFILL" light will be
OFF.) Turn machine “ON.”
Check for proper brew levels.
Turn “OFF” and unplug machine.
Turn pressure down to 0 P.S.I. by directing the steam wand
over the drain pan and pulling down the steam handle.
Take out main heater by removing four bolts and disconnect
the two wire terminals.
Check for buildup on heater. De-lime or replace heater if
necessary.
Siphon water out of the boiler and check for clarity. Refill
with water.
Cover the heater terminal wires with electrical tape.
With main power switch of machine “OFF,” plug in machine.
Boiler will begin to fill. Check for fill time of 3 to 5 minutes.
Look for proper water level to be about 3 inches from the
top of boiler.
Repeat as necessary.
If all is correct, unplug and reinstall heater using a new
heater gasket.
Turn “OFF” and unplug machine.
Turn “OFF” water supply.
Remove strainer bolt.
Remove strainer and clean.
Reinstall strainer.
Turn on water.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grindmaster Espressimo 1750 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grindmaster Espressimo 1750 in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info