644639
27
Zoom out
Zoom in
Previous page
1/34
Next page
27
PROBLEM POSSIBLE CAUSE SOLUTION
Handle not in Carriage bolts not seated Adjust the height of the handle and make
position. properly. sure the carriage bolts are seated properly
Handle knobs not tightened. Tighten handle knobs.
Mower not starting. Extension cord not connected to Reconnect the cord and use the cord
the mower plug. retainer to keep the cord close to the
motor/blade control.
Extension cord not connected Connect the extension cord to a live
to power source. 120V AC, 60 HZ AC receptacle.
Motor control switch defective. Have motor control switch replaced
by an authorized service center.
Mower cutting Lawn is rough or uneven or Move the wheels to a higher position.
unevenly. height not set properly. All wheelsmust be placed in the same
cutting height for the mower to cut evenly.
Mower not mulching Wet grass clipping s sticking to Wait until the grass dries before mowing.
properly. the underside of the deck.
Mower hard to push. High grass, rear of mower Raise cutting height.
housing and blade dragging in
heavy grass, or cutting height
too low.
Mower vibrating at Blade is unbalanced. Balance the blade by grinding each
higher speed. cutting edge equally.
Bent motor shaft. Stop the motor, disconne ct the power
source, and inspect for dam age. Have
repaired by an authorized service center
before restarting.
TROUBLESHOOTING
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Greenworks 25022 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Greenworks 25022 in the language / languages: English as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info