644658
13
Zoom out
Zoom in
Previous page
1/42
Next page
13
ADDING BAR AND CHAIN LUBRICANT (See Figure 6)
Use Bar and Chain Lubricant. It is designed for chains and chain oilers, and is formulated to
perform over a wide temperature range with no dilution required.
NOTE: Chain saw comes from the factory with no bar and chain oil added. Level should also be checked after
Remove oil cap.
Carefully pour the bar and chain oil into the tank.
Wipe off excess oil.
Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.
DO NOT re-
move the foam.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank after
each use then run for one minute. When storing the unit for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent rust on the chain and bar sprocket.
I M P O R T A N T
To preserve natural resources, please recycle or dispose of oil properly. Consult your local waste
authority for information regarding available recycling and/disposal options.
OPERATING YOUR CHAIN SAW
Fig. 6
Quick View
Oil Indicator
C HAIN
LUBRICANT
Oil Reservoir
Cap
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Greenworks 20312 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Greenworks 20312 in the language / languages: English as an attachment in your email.

The manual is 16,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info