627693
7
Zoom out
Zoom in
Previous page
1/60
Next page
2007 POWER FINDER™ Circuit Tracer
7
Greenlee Textron Inc. / Subsidiary of Textron Inc.
4455 Boeing Dr., Rockford, IL 61109-2988 USA 815/397-7070
The green POWER LED will glow. (If it doesn’t, remove and
replace the 9 volt battery, which is accessed by sliding the small
battery door on the rear of the receiver to the open position).
Continue to move the GAIN knob in the clockwise direction until
it has reached its maximum travel. Move the receiver to within a
few inches of the transmitter. All 4 red LEDs will intermittently
glow, and the unit will emit a beeping sound. The 2007 is now
ready to operate.
3) Take the receiver to the vicinity of the suspected power source
for the circuit being tested. If a signal is received, move the
receiver toward the equipment, producing the increase in signal
strength. (The receiver will pick up a signal within 12 to 18
inches of a panel, even with the panel cover closed).
4) If the signal is present, open the door, position the RANGE
switch to LOW and move the receiver slowly down the row of
breakers or fuses as shown below.
NOTE:
The receiver
must be held in the
position shown here to
be properly aligned
with the magnetic field
produced by the
transmitter and provide
maximum performance.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Greenlee 2007 POWER FINDER at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Greenlee 2007 POWER FINDER in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info