505372
17
Zoom out
Zoom in
Previous page
1/25
Next page
Installation service - Notices for installation
17
Important Notices
Basic Requirements For Installation Position
Indoor Unit Installation Position Selection
1. The unit must be installed by a qualified technician according to local regulations and the instructions
in this manual.
2. If the air conditioner the instructions in plug, connect it directly to a fixed circuit, A breaker should
be installed in the fixed circuit. All the breaker's poles should be switched off and the distance of the
contact should be at least 3mm.
1. The air inlet and outlet vent should be free of obstruction. Ensure that the air can be blown
through the whole room.
2. Select a position where the condensing water can be easily drained out, and the place is easily
connected for the outdoor unit.
3. Select a location that is out of the reach of children.
4. Use an installation location that is strong enough to withstand the full weight and vibration of
the unit, and that will not increase the noise.
5. Be sure to leave enough space to allow access for routine maintenance. The height of the
installation location should be 250 cm or more from the floor.
6. Select a place about 1m or more away from a TV set or any other electric appliances.
7. Select a place where the filter can be easily taken out.
8. Make sure that the indoor unit installation is in line with the installation dimension
diagram requirements.
Installing the unit in the following ing the unit may cause malfunctions. If it is unavoidable
please contact with service. Any place where:
• Strong heat sources, vapors, flammable gas or volatile fumes or liquids are emitted.
• High-frequency waves are generated by radio equipment, welders and
medical equipment.
• High levels of salinity exist, such as on the coast.
• There is oil (machine oil) the air.
• Sulfuric gas is generated, such as near hot springs.
• Other special circumstances exist.
Service d’installation – instructions
17
Instructions importantes
Exigences de base de l’installation
Installation de l’appareil interne
1. L’appareil doit être installé par un technicien qualifié selon les règlements locaux et ce manuel.
2. Si le conditionneur d’air ne comporte pas de fiche, branchez-le directement dans le circuit fixe. Un
disjoncteur devrait être ajouté au circuit fixe. Toutes les polarités des disjoncteurs doivent être
désactivées et la distance de contact doit être d’au moins 3 mm.
1. L’entrée et la sortie d’air ne doivent pas être obstruées. Assurez-vous que l’air peut être soufflé partout
dans la pièce.
2. Choisissez un endroit qui permet de drainer facilement l’eau condensée et d’accéder facilement à
l’appareil externe.
3. Choisissez un endroit où les enfants ne peuvent pas atteindre l’appareil.
4. Choisissez un endroit assez robuste pour supporter le poids et la vibration de l’appareil et où celui-ci
ne sera pas plus bruyant.
5. Laissez un espace suffisant autour de l’appareil pour faciliter son entretien. L’appareil devrait être
installé à au moins 250 cm (10 po) du plancher.
6. L’appareil doit être installé à au moins 1 m (3 pi) d’un téléviseur ou d’un autre appareil électrique.
7. Choisissez un endroit où le filtre peut être atteint facilement.
8. Assurez-vous que l’appareil interne est installé selon les exigences du diagramme des dimensions pour
l’installation.
Installer l’appareil aux endroits suivants peut l’empêcher de fonctionner. Si aucune autre
option ne s’offre à vous, communiquez avec un centre de service.
• Fortes émanations provenant de sources de chaleur, de vapeurs, de gaz inflammables ou
objets volatiles.
• Ondes hautes fréquences provenant d’une radio, de soudeurs ou d’un équipement
médical.
• Taux élevé de salinité, comme sur le bord de la mer.
• Présence d’huile (machine à l’huile) dans l’air.
• Gaz sulfureux provenant de sources hydrothermales.
• Autres circonstances spéciales.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gree GWC-12KF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gree GWC-12KF in the language / languages: English as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info