637246
106
Zoom out
Zoom in
Previous page
1/117
Next page
Page 42/53
11-2. DISCHARGE START
- DISCHARGE PROCESS
a. AUTOMATIC
Discharging calculating battery cell and discharge current
automatically.
The charger calculates battery internal resistance and discharge
currents every specific time.
CUTOFF VOLTAGE:
NiCd=0.9V/cell
NiMh=1.0V/cell
LiIo/Po=3.0V/cell
LiFe=2.5V/cell
Pb=1.8V/cell
Calculating and finish discharging based on above.
Cut-TEMP which is used in charging is used.
c. NORMAL
Discharge is OFF every one minute.
Average resistance is gained every one minute.
d. LINEAR
Continues to discharge without stopping.
Internal resistance is gained one time only 3 minutes after starting
discharge.
e. MATCH
refer to 3-5. MATCHED VOLT
“When each cell voltage tolerance is higher as 7mV, discharge is
checked, cell balancing is active and ‘CHK: MATCHED’ should be
shown on the screen. If the cell voltage tolerance becomes within
7mV it shows ‘END:MATCHED’.
Checking is continued and balanced (it takes time).
User can check cell tolerance and finish MATCH mode.
f. LINK
This is only for Lilo/LiPo/LiFe.
This is the same discharge method with CV-LINK charge.
11-3. CYCLE START
- PROCESS SELECT
Select wanted charge process.
Select wanted discharge process.
106


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner PRX-5A - 6444 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner PRX-5A - 6444 in the language / languages: German as an attachment in your email.

The manual is 3,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info