30127
41
Zoom out
Zoom in
Previous page
1/48
Next page
ELEV D/R
The gear channel operates from the elevator dual rate
switch.
INHIBIT
The gear channel is inhibited and is centered making it
useful as a slave channel for mixing.
RIGHT SW
The gear channel operates from the right upper (flap)
switch.
Flight Mode
LEFT SW (default)
The flight mode operates from the left upper (gear)
switch.
AILE D/R
The flight mode operates from the aileron dual rate
switch
ELEV D/R
The flight mode operates from the elevator dual rate
switch.
RIGHT SW
The flight mode channel operates from the right upper
switch.
Wing Type Selection
There are three different wing types to choose from; se-
lect the one that will best suit your RC aircraft. Flaperon,
Elevon and V-Tail are available selections for Wing Type
and will be covered in the following pages.
Wing Type
V-Tail indicator
Go to Model Select
menu
Go to Switch Select
menu
Turn selected type
on or off
Return to Default
mode
Definition of Wing Types
Normal
This is used with aircraft with one servo operating both
ailerons. This mode is the default setting and is active
when the Flapneron, Elevon and V-Tail modes are off.
Flaperon
This mode is used when two servos are used to
operated the ailerons. Flaperons allow each aileron
to be independently adjusted. In addition, they can be
programmed to move in the same direction for use as
flaps or spoilers.
Elevon
This mode is used for some types of delta wing aircraft
where the control surfaces function as both ailerons and
elevators.
V-Tail
Used for V-tailed airplanes
Note: Some function will be unavailable when certain
functions are active. With Flaperon active,
Elevon will be unavailable. With Elevon active,
both Flaperon and V-Tail will be unavailable.
Finally, with V-Tail active, Elevon will be unavai-
lable.
Flaperon Wing Type Selection
Flaperons allow you to use the existing ailerons as
flaps. The ailerons can be raised or lowered in unisonas
flaps, yet still remain fully operational as the ailerons of
your RC airplane.
System Mode 41
System Mode
Wing Type Selection
Connect this servo to the
AUX 1 port of the receiver
Connect this servo to the
aileron port of the receiver
Accessing and Utilizing the Flaperon Wing Type
Selection
1. While the Down and Select buttons are pressed,
move the power switch to the ON position to access
the System mode.
2. Press either the Up or Down keys until WING
TYPE appears in the upper area of the LCD.
3. Press either the (+) or (-) key to turnon the Flaperon
(FLPR) Wing Type Selection.
Note: For Flaperon, one servo must be used for each
aileron control surface.
4. Plug the left wing aileron servo into the Auxiliary
1 (AUX1) port of your JR receiver. Connect the right
aileron servo into the aileron port (AILE) of your
receiver.
5. Check to make sure that the wing servos move in
the proper direction. For a right turn, the right aileron
should raise while the left aileron lowers simultane-
ously. For a left turn, the opposite is true; the left
aileron should rise while the right aileron drops.
If your servos are not moving in the direction just
described, use the Servo Reversing function to
reverse the the travel direction of the servo(s) that
are moving improperly. Refer to the Servo Reversing
section for information on how to reverse the travel
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MX12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MX12 in the language / languages: English as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MX12

Graupner MX12 User Manual - English, German - 144 pages

Graupner MX12 User Manual - Dutch - 47 pages

Graupner MX12 User Manual - French - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info