30127
60
Zoom out
Zoom in
Previous page
1/144
Next page
12 Connections and installations
Connections and installations
For Airplane
BATTERY
RECEIVER
SWITCH HARNESS
FLAP
CHANNEL
GEAR
CHANNEL
RUDDER
CHANNEL
ELEVATOR SERVO
AILERON SERVO
THROTTLE SERVO
FLAP
(AUX1)
GEAR
RUDD
ELEV
AILE
THRO
WARNING
Do not cut or fold the antenna!
ANTENNA
R700 RECEIVER
Servo Mounting Tab
Screw
Rubber Grommet
Brass Eyelet
Installation requirements
It is extremely important that your radio system be cor-
rectly installed in your model. Here a few suggestions
installing your GRAUPNER equipment:
1. Wrap the receiver in protective foam rubber that
is no less than 3/8 inch thick. Secure the foam to
the receiver with #64 rubber bands. This protects
the receiver in the event of a crash or a very hard
landing.
2. The servos should be mounted using rubber grom-
mets and brass eyelets to isolate them from vibrati-
on. Do not over-tighten the mounting screws; this will
negate the vibration absorption effect of the rubber
grommets. The following diagram will assist you in
properly mounting your servo. The brass eyelet are
pushed from the bottom up in the rubber grommets.
When the servo screw is tightened securely, it provi-
des the proper security as well as the proper vibrati-
on isolation for your servo.
3. The servos must be able to move freely over their
entire range of travel. Make sure that the control
linkages do not bind or impede the movement of any
of the servos.
4. Mount all switches away from the engine exhaust
and away from any high vibration areas. Make sure
the switch operates freely and is able to operate over
its full travel.
5. Mount the receiver antenna firmly to the airplane
to ensure that it will not become entangled on the
propeller or control surfaces.
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MX12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MX12 in the language / languages: English, German, French as an attachment in your email.

The manual is 15,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MX12

Graupner MX12 User Manual - English - 48 pages

Graupner MX12 User Manual - Dutch - 47 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info