354448
32
Zoom out
Zoom in
Previous page
1/42
Next page
GB
32
Compressor does not run
- Check the temperature setting.
- Check to ensure that power is switched
on and that the plug has been properly
inserted into the wall socket.
Unfamiliar sounds
Can be caused by tubes in the appliance
contacting each other or the outer cladding.
- Check to make sure the refrigerator is
standing level.
Liquid noice
Caused by circulating refrigerant. This is
quite normal, even when the compressor is
not running.
Note also
The compressor starting system often
needs a pause before it can be restarted.
The compressor will itself automatically
decide how long the pause is to be.
Blocked defrost/melt water drain
If blockage does occur, the most likely point
is the plastic bend at the outlet inside the
cabinet. Carefully remove the blockage,
then for safety’s sake clean the bend with a
pipe cleaner or similar.
If the problem persists, the blockage might
be in the tube down to the evaporation tray.
The tray is located above the compressor
at the rear of the refrigerator.
When ordering spare parts, please give the
refrigerator type and part number. This
information is given on the nameplate
inside the cabinet.
Use a 15 Watt, 240 Volt bulb with a
miniature base.
Turn the lock a quarter turn and re-
move the screen to gain access and
change the bulb.
15
14
7
3
Defrosting is fully automatic, controlled by
a sensor which ensures that cooling does
not start until the evaporator has been
completely defrosted.
If, nevertheless, an unusual amount of fro-
st does build up, manual defrosting is pos-
sible by turning the temperature regulating
knob counterclockwise to "0" and waiting
for the frost to disappear.
Once the evaporator is free of ice, start the
cooling again by turning the temperature
regulating knob clockwise towards "Max.".
Do not turn the knob right back to its "old"
position.
The cabinet is best cleaned with a weak
soap solution.
Do not use cleaning agents that might
cause scratches.
The life of the sealing strip will be pro-
longed if it is clened regularly.
The plastic parts cannot withstand boiling
water (max. temp. 85°C).
Door sticking:
Opening and closing the door creates
underpressure in the cabinet. If you need
to open and close the door repeatedly
within a short period, lay something betw-
een the door sealing strip and cabinet front
edge to create an air gap.
The refrigerator is to remain unused for
a time
After the refrigerator has been defrosted
and cleaned, leave the door slightly ajar.
This will prevent bad smells.
Defrosting
Cleaning
Useful hints
Spare parts
Replacing the bulb
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gram ks 200 01 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gram ks 200 01 in the language / languages: English, German, Dutch, Danish, French, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info